Ironing on Edge Banding Without Damaging It355

As a professional Chinese edge banding factory, we understand the challenges furniture makers face when working with edge banding. One common issue is damaging the edge banding during the ironing process. To help resolve this problem, we've compiled a comprehensive guide on how to iron on edge banding without causing any harm.

Preparation:
Ensure that the edge banding and the substrate are both clean and free of dust or debris.
Trim the edge banding to the desired length and apply a thin layer of adhesive to the back of the banding.
Place the edge banding on the edge of the substrate, aligning it carefully.

Ironing:
Use a medium-heat setting on the iron. Too high of a heat will burn or melt the edge banding, while too low of a heat will not provide enough adhesion.
Apply moderate pressure to the iron as you move it along the edge banding. Hold the iron in one spot for too long can cause the banding to scorch or bubble.
Move the iron back and forth along the banding, ensuring that the adhesive is evenly distributed and the banding is firmly attached to the substrate.

Cooling and Trimming:
Once the edge banding is ironed on, allow it to cool completely before trimming any excess material.
Use a sharp utility knife or a flush trim router to trim the excess edge banding flush with the substrate.
Sand the trimmed edge lightly to smooth any rough edges or splinters.

Tips for Avoiding Damage:
Use a heat-resistant protective cover over the edge banding while ironing to prevent scorching or melting.
Iron in short, even strokes to avoid overheating any specific area.
Apply firm but gentle pressure to the iron to avoid tearing or deforming the edge banding.
If the edge banding starts to curl or bubble, stop ironing immediately and adjust the heat setting or the pressure.
Allow the iron to cool completely before picking up or moving the workpiece.

By following these steps and tips, you can effectively iron on edge banding without causing any damage. This will result in a professional-looking finish that will enhance the appearance and durability of your furniture.

2024-10-21

Previous：Solid Wood Veneer Edging Process

Next：Edge Banding Methods and Edge Banding Tapes in Wardrobe Production