How to Edgeband a Curved Edge with L-Shaped Edging224

L-shaped edging is a versatile and cost-effective solution for finishing curved edges on furniture and other woodworking projects. It provides a clean, professional-looking finish that protects the edge of the workpiece from damage. While it may seem like a daunting task, edgebanding a curved edge with L-shaped edging is actually quite straightforward with the right tools and techniques.

Materials You'll Need:* L-shaped edging
* Adhesive
* Contact cement
* Sandpaper
* Router with roundover bit
* Trim router with flush trim bit
* Clamps

Step 1: Prepare the Workpiece* Sand the edge of the workpiece to remove any splinters or imperfections.
* Apply a thin layer of adhesive to the edge of the workpiece.

Step 2: Apply the Contact Cement* Apply a thin layer of contact cement to the back of the L-shaped edging.
* Allow the contact cement to become tacky for a few minutes.

Step 3: Position the Edging* Carefully align the L-shaped edging with the edge of the workpiece.
* Press the edging firmly into place, starting at one end and working your way around the curve.
* Use clamps to hold the edging in place while the adhesive sets.

Step 4: Trim the Excess Edging* Use a trim router with a flush trim bit to trim away the excess edging that overhangs the edge of the workpiece.
* Be careful not to press too hard, as you could damage the edging.

Step 5: Round Over the Edge* Use a router with a roundover bit to round over the exposed edge of the L-shaped edging.
* This will create a smooth, finished edge that is less likely to chip or peel.

Step 6: Sand and Finish* Sand the edge of the workpiece to smooth out any rough spots.
* Apply a finish of your choice, such as paint, stain, or clear lacquer.

Tips for Success:* Use a sharp router bit to ensure a clean, precise cut.
* Apply the contact cement evenly to avoid gaps or bubbles.
* Allow the adhesive to become tacky before positioning the edging to prevent it from sliding out of place.
* Use clamps to hold the edging securely while the adhesive sets.
* Trim the excess edging slowly and carefully to avoid tearing the material.
* Sand the edge lightly to remove any sharp edges.
* Apply a finish that is compatible with the edging material and the intended use of the workpiece.

2024-10-21

Previous：How to Use Furniture Edge Banding Pliers

Next：How to Apply Pre-Glued Edge Banding