Metal Edging: How to Install Edging Trim363

Metal edging is a versatile and durable option for finishing the edges of furniture, countertops, and other surfaces. It provides a clean, finished look and protects the underlying material from wear and tear. The installation process is relatively simple and can be done with basic tools.

Materials You Will Need* Metal edging
* Measuring tape
* Pencil
* Miter saw or sharp utility knife
* Contact cement
* Clamps
* Sandpaper (optional)

Step 1: Measure and Cut the EdgingMeasure the length of the edge that you want to cover and cut the edging to size using a miter saw or a sharp utility knife. If you are using a miter saw, make sure to cut the edging at a 45-degree angle so that the pieces will fit together seamlessly.

Step 2: Apply Contact CementApply a thin layer of contact cement to the edge of the surface and the back of the edging. Allow the cement to dry for a few minutes until it becomes tacky.

Step 3: Position the EdgingAlign the edging with the edge of the surface and press it into place. Use clamps to hold the edging in place while the cement dries.

Step 4: Remove the ClampsAfter the cement has dried completely, remove the clamps. You may need to use a rubber mallet or a hammer to gently tap the edging into place to ensure that it is securely fastened.

Step 5: Sand the Edging (Optional)If desired, you can sand the edging to smooth out any rough edges or to match the finish of the surface. Use fine-grit sandpaper and work slowly and carefully to avoid damaging the edging.

Tips for Installing Metal Edging* Make sure to clean the surface and the edging before applying the contact cement. This will help to ensure a strong bond.
* If you are using a miter saw to cut the edging, use a sharp blade and cut slowly to avoid tearing the metal.
* Apply even pressure when applying the edging to the surface. This will help to prevent the edging from buckling or warping.
* If the edging does not fit perfectly, you can use a utility knife to trim off any excess material.
* Metal edging can be painted or stained to match the finish of the surface.

2024-10-23

Previous：How to Edgeband Metal Edgebanding on an Edgebander Machine

Next：How to Apply Edge Banding in the Woodworking Shop