How to Apply Edge Banding to Cabinet Doors151

Edge banding is a thin strip of material that is applied to the edges of wood panels to create a finished look. It can be used on both straight and curved edges, and it is available in a wide variety of materials, including wood, plastic, and metal. Applying edge banding is a relatively simple process, but it does require some patience and attention to detail.

The following steps will show you how to apply edge banding to cabinet doors:
Prepare the surface. The first step is to prepare the surface of the wood panel that you will be applying the edge banding to. This involves cleaning the surface with a damp cloth to remove any dirt or debris, and then sanding it lightly with a fine-grit sandpaper to create a smooth surface.
Apply the adhesive. Once the surface is prepared, you can apply the adhesive to the back of the edge banding. You can use either a brush or a roller to apply the adhesive evenly. Be sure to apply a thin, even coat of adhesive, and avoid getting any adhesive on the front of the edge banding.
Position the edge banding. Once the adhesive has been applied, you can position the edge banding on the edge of the wood panel. Start at one end of the panel and work your way to the other end, pressing the edge banding into place as you go. Use a rubber mallet or a soft cloth to tap the edge banding into place, and be sure to apply even pressure along the entire length of the edge banding.
Trim the excess. Once the edge banding has been applied, you can trim the excess material using a sharp knife or a utility knife. Be careful not to cut too close to the edge of the wood panel, as this could damage the edge banding.
Finish the edge banding. The final step is to finish the edge banding. This can be done by sanding the edge banding lightly with a fine-grit sandpaper, and then applying a clear finish such as polyurethane or lacquer.

2024-10-23

Previous：How to Apply ABS Edge Banding to Your Furniture

Next：How to Hand-Apply Edge Banding