Can You Recut Edge Banding?103

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, particleboard, or MDF (medium-density fiberboard) to give it a finished look and protect it from moisture and wear. Edge banding can be made from a variety of materials, including wood, plastic, metal, and paper.

If you have a piece of furniture that has damaged edge banding, you may be wondering if you can recut it. The answer is yes, you can recut edge banding, but it is important to do it correctly in order to get a good result.

How to Recut Edge Banding1. Remove the old edge banding. To do this, you will need to use a sharp utility knife to score the edge banding along the edge of the furniture. Once you have scored the edge banding, you can use a putty knife or a small chisel to pry it off.
2. Clean the surface of the furniture. Once you have removed the old edge banding, you will need to clean the surface of the furniture to remove any glue or debris. You can do this using a damp cloth or a tack cloth.
3. Apply new edge banding. To do this, you will need to cut a new piece of edge banding to the correct length. Once you have cut the edge banding, you will need to apply a thin layer of glue to the back of it. You can then press the edge banding into place on the furniture.
4. Trim the edge banding. Once you have applied the new edge banding, you will need to trim it so that it is flush with the edge of the furniture. You can do this using a sharp utility knife.
5. Sand the edge banding. Once you have trimmed the edge banding, you will need to sand it to smooth it out. You can do this using a sanding block or a sanding sponge.

Tips for Recutting Edge Banding* Use a sharp utility knife. A sharp utility knife will help you to get a clean cut when you are scoring the old edge banding.
* Be careful not to damage the surface of the furniture. When you are removing the old edge banding, be careful not to damage the surface of the furniture. You can use a putty knife or a small chisel to pry off the edge banding, but be careful not to gouge the wood.
* Apply a thin layer of glue to the back of the new edge banding. A thin layer of glue will help to hold the new edge banding in place. Do not apply too much glue, as this can make it difficult to remove the edge banding if you need to make any adjustments.
* Trim the edge banding flush with the edge of the furniture. When you are trimming the edge banding, be careful not to trim it too short. If you trim the edge banding too short, it will not be flush with the edge of the furniture and will look unfinished.
* Sand the edge banding to smooth it out. Sanding the edge banding will help to smooth it out and give it a finished look. You can use a sanding block or a sanding sponge to sand the edge banding.

ConclusionRecutting edge banding is a relatively simple process, but it is important to do it correctly in order to get a good result. By following the steps outlined in this article, you can recut edge banding on your furniture and give it a new finished look.

2024-10-23

Previous：Edge Banding with a Rough Surface

Next：Edge Banding Rounding Over Video