How to Edgeband a Round Hole with Edgebanding203

When it comes to edgebanding, round holes can be a bit tricky, but it's definitely possible to achieve a professional-looking finish. Here are the steps on how to edgeband a round hole:

1. Prepare the edge of the hole.
Make sure that the edge of the hole is even and smooth. If there are any burrs or splinters present, use sandpaper or a sanding block to remove them. Then, apply a thin bead of wood glue around the edge of the hole.

2. Cut the edgebanding strips.
Cut the edgebanding strips 1-2 inches longer than the length of the hole. The width should be wide enough to cover the edge of the hole plus 1/8 inch overhang.

3. Apply the edgebanding strips.
Start by placing a bead of wood glue on the underside of one of the edgebanding strips. Then, carefully align the strip with the edge of the hole and press it into place. Repeat with the other edgebanding strip on the opposite side of the hole.

4. Trim the edgebanding strips.
Use a sharp utility knife or a pair of scissors to trim the excess edgebanding strips flush with the surface of the material.

5. Sand the edges.
Use sandpaper or a sanding block to sand the edges of the edgebanding strips smooth and flush with the surface of the material.

6. Finish as desired.
The edgebanded hole is now complete. You can now finish it as desired, such as by applying stain, paint, or a clear finish.

Here are some additional tips for edgebanding a round hole:
Use a sharp utility knife or a pair of scissors for cutting the edgebanding strips. A dull blade will tear the edgebanding and make it difficult to get a clean edge.
Be careful not to apply too much wood glue. Too much glue will squeeze out from between the edgebanding and the material, making it difficult to clean up.
If the edgebanding strips are not perfectly aligned, you can use a rubber mallet to gently tap them into place.
Sand the edges of the edgebanding strips smooth and flush with the surface of the material. This will help to create a professional-looking finish.
If desired, you can apply stain, paint, or a clear finish to the edgebanded hole to protect it and improve its appearance.

2024-10-23

Previous：How to Apply Edge Banding to Curved Surfaces

Next：How to Edge Band with Sintered Stone Edging Strips