How to Apply Edge Banding to Kitchen Cabinet Supports264

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, particleboard, or MDF to create a finished look and prevent moisture damage. It is a common technique used in cabinetry, particularly for kitchen cabinets. Cabinet supports, also known as cabinet stiffeners, are typically made of the same material as the cabinet itself and are used to provide additional strength and support to the cabinet structure. Applying edge banding to cabinet supports is a straightforward process that can be completed with a few simple tools and materials.

Materials* Edge banding material (melamine, PVC, veneer, etc.)
* Contact cement
* Rag or brush
* Scissors or utility knife
* Flush trim bit or hand-held router
* Sandpaper

Instructions1. Prepare the cabinet support. Remove any dirt or debris from the edge of the cabinet support and ensure that it is smooth and free of any imperfections. If necessary, sand the edge lightly to create a smooth surface for the edge banding.
2. Apply contact cement to the cabinet support and the edge banding. Use a rag or brush to apply a thin, even coat of contact cement to both the edge of the cabinet support and the back of the edge banding. Allow the contact cement to dry for a few minutes until it becomes tacky.
3. Align and apply the edge banding. Carefully align the edge banding with the edge of the cabinet support and press it into place. Use a roller or a piece of wood to apply firm pressure along the entire length of the edge banding to ensure that it adheres properly.
4. Trim the excess edge banding. Use a flush trim bit or a hand-held router to trim the excess edge banding that extends beyond the edge of the cabinet support. Be careful not to cut into the cabinet support itself.
5. Sand the edge banding. Use sandpaper to smooth the edges of the edge banding and remove any rough spots or imperfections.

Tips* Use a sharp utility knife or scissors to cut the edge banding to the desired length.
* Apply the contact cement in a well-ventilated area as it can release fumes.
* Allow the contact cement to dry sufficiently before applying the edge banding to ensure a strong bond.
* If you are using a hand-held router to trim the edge banding, use a sharp bit and make sure to wear safety glasses.
* If you are applying edge banding to a large or complex cabinet support, it may be helpful to use a vacuum press to ensure a tight bond.

ConclusionApplying edge banding to cabinet supports is a simple and effective way to enhance the appearance and durability of your cabinets. By following these instructions carefully, you can achieve professional-looking results that will last for years to come.

2024-10-23

Previous：How to Install Edge Banding with T-Molding

Next：How to Apply Veneer Edge Banding to Particleboard