How to Edge Band Shaped Panels120

##
Edge banding is an essential part of finishing shaped panels, as it provides a clean and polished look while also protecting the edges of the panel from damage. The process of edge banding a shaped panel can be more challenging than edge banding a straight panel, but with the right tools and techniques, it is possible to achieve a professional-looking result.


Tools for Edge Banding Shaped Panels
* Edge bander with a shaped edge guide
* Hot melt glue
* Edge banding tape/strips
* V-knife tool
* Hand router
* Trim router
* Flush trim bit


Step-by-Step Guide to Edge Banding Shaped Panels
1. Prepare the panel:
- Ensure that the panel is clean and free of dust.
- If necessary, sand the edges of the panel to remove any rough edges.
2. Apply hot melt glue to the edges of the panel:
- Use a hand-held glue gun to apply a thin layer of hot melt glue to the edges of the panel.
3. Install the edge banding:
- Place the edge banding tape/strips on the edges of the panel and press it into the hot melt glue.
- Use a shaped edge guide on your edge bander to ensure that the edge banding is applied evenly and smoothly.
4. Trim the excess edge banding:
- Use a V-knife tool to trim any excess edge banding that is hanging over the edges of the panel.
5. Flush trim the edge banding:
- Use a hand router or trim router with a flush trim bit to flush trim the edge banding with the surface of the panel.
6. Sand the edges:
- Sand the edges to remove any sharp edges or imperfections and create a smooth finish.
Tips for Edge Banding Shaped Panels
* Use a sharp V-knife tool to ensure clean cuts.
* Practice on scrap material to get the hang of the process before edge banding the actual panel.
* Use a shaped edge guide that closely matches the shape of the panel.
* Apply even pressure to the edge bander to avoid applying too much pressure in areas.
* Allow the hot melt glue to cool completely before trimming the edge banding.
* Sanding the edges will help to create a smooth and professional-looking finish.


Conclusion
Edge banding shaped panels can be a challenging task, but with the right tools and techniques, it is possible to achieve a professional-looking result. By following the steps outlined above, you can edge band shaped panels like a pro.

2024-10-23

---

Previous：Edge Banding Failed to Seal Panel Edges? Here‘s How to Fix It

Next：How to Seal Edge Banding That Is Covered by Cabinet Doors