How to Cut Edge Banding Strips206

Edge banding strips are used to cover the exposed edges of plywood, MDF, and other wood-based panels. They provide a finished look to the panel and help to protect it from moisture and damage. Edge banding strips can be cut to any length using a variety of tools, including a utility knife, a miter saw, or a table saw.

Cutting Edge Banding with a Utility Knife

To cut edge banding with a utility knife, follow these steps:
Measure the length of the edge that you need to cover. Add 1 inch to the measurement to allow for overlap.
Mark the length on the edge banding strip.
Place the edge banding strip on the panel, aligning the mark with the edge of the panel.
Hold the edge banding strip in place with one hand and use the utility knife to score the strip along the mark. Be sure to apply firm pressure to the knife.
Once the strip is scored, bend it back and forth to break it along the score line.
Trim the excess edge banding strip from the edges of the panel.

Cutting Edge Banding with a Miter Saw

To cut edge banding with a miter saw, follow these steps:
Measure the length of the edge that you need to cover. Add 1 inch to the measurement to allow for overlap.
Mark the length on the edge banding strip.
Set the miter saw to a 45-degree angle.
Place the edge banding strip on the miter saw table, aligning the mark with the saw blade.
Hold the edge banding strip in place with one hand and use the miter saw to cut the strip at a 45-degree angle.
Trim the excess edge banding strip from the edges of the panel.

Cutting Edge Banding with a Table Saw

To cut edge banding with a table saw, follow these steps:
Measure the length of the edge that you need to cover. Add 1 inch to the measurement to allow for overlap.
Mark the length on the edge banding strip.
Set the table saw blade to a height of 1/4 inch.
Place the edge banding strip on the table saw table, aligning the mark with the saw blade.
Hold the edge banding strip in place with one hand and use the table saw to cut the strip at a 90-degree angle.
Trim the excess edge banding strip from the edges of the panel.

Tips for Cutting Edge Banding Strips

Here are a few tips for cutting edge banding strips:
Use a sharp blade. A dull blade will tear the edge banding strip and make it difficult to get a clean cut.
Apply firm pressure to the cutting tool. This will help to prevent the edge banding strip from slipping and tearing.
Cut slowly and carefully. Rushing the cut can result in mistakes.
Wear safety glasses. This will protect your eyes from flying wood chips.

2024-11-24

Previous：Why Banding Edge Trimmings Matter: A Guide from a Chinese Manufacturer

Next：Is Sophia Edge Banding Good? Here‘s Everything You Need to Know