How to Edge Band with 5cm Wide Edge Banding138

Edge banding is a vital process in furniture manufacturing, as it protects the exposed edges of panels from moisture, damage, and wear. When working with 5cm wide edge banding, there are specific steps and considerations to ensure a professional and durable finish.

Materials Required:
5cm wide edge banding
Edge banding machine
Trimming router
Flush trim bit
Sanding block
Contact cement

Steps:

1. Prepare the Edge: Clean the edge of the panel thoroughly to remove any debris or imperfections. Ensure the edge is straight and smooth.

2. Apply Contact Cement: Apply a thin, even layer of contact cement to both the edge of the panel and the edge banding. Allow it to dry for a few minutes until it becomes tacky.

3. Apply the Edge Banding: Align the edge banding with the edge of the panel and press it firmly into place. Use a rubber roller or hand roller to apply pressure and ensure good adhesion.

4. Trim the Excess: Once the edge banding is applied, use a trimming router with a flush trim bit to remove any excess material. Move the router slowly and carefully to avoid damaging the panel.

5. Sand the Edge: Use a sanding block with fine-grit sandpaper to smooth the edges and remove any remaining burrs or imperfections. Sand parallel to the grain to avoid tearing the edge banding.

Tips:
Use high-quality edge banding and contact cement to ensure a strong bond.
Allow sufficient drying time for the contact cement before applying the edge banding.
Apply pressure evenly across the entire length of the edge banding.
Use a sharp flush trim bit to ensure a clean and precise cut.
Wear appropriate safety gear, such as gloves and a dust mask, when using power tools.

By following these steps and tips, you can achieve a professional-looking and durable edge band finish on your furniture panels using 5cm wide edge banding.

2024-12-17

Previous：How to Fix Un-edged Edging Tape on Chinese Furniture

Next：How to Fix Debonding Edge Banding on Furniture