[VIDEO] How to Edge Band Without Pre-Applied Adhesive84

In this video, we'll show you how to edge band without pre-applied adhesive using a hot melt adhesive. This method is ideal for small to medium-sized projects and can be used on a variety of materials, including wood, plastic, and metal.

What You'll Need* Edge banding
* Hot melt adhesive
* Edge bander
* Trim router
* Sandpaper
* Iron (optional)

Step 1: Prepare the Edge Banding* Cut the edge banding to the desired length.
* If the edge banding is not flexible enough, you can apply heat with an iron to make it more pliable.

Step 2: Apply the Hot Melt Adhesive* Apply a thin layer of hot melt adhesive to the edge of the workpiece.
* You can use a hot melt glue gun or an edge bander to apply the adhesive.

Step 3: Apply the Edge Banding* Position the edge banding on the workpiece and press it firmly into place.
* Use a roller or a hand-held press to ensure that the edge banding is fully adhered.

Step 4: Trim the Edge Banding* Use a trim router to trim the excess edge banding.
* Be sure to use a sharp bit and to follow the manufacturer's instructions for your router.

Step 5: Sand the Edge Banding* Sand the edge banding to smooth out any rough edges.
* You can use a sanding block or a handheld sander.

Tips* For best results, use a hot melt adhesive that is specifically designed for edge banding.
* If you are using an edge bander, be sure to adjust the temperature and speed according to the manufacturer's instructions.
* If the edge banding is not adhering properly, you can apply additional hot melt adhesive to the workpiece.
* Be careful not to overheat the edge banding, as this can cause it to melt or burn.

Troubleshooting* If the edge banding is not sticking, it may be because the adhesive is not hot enough. Increase the temperature of the glue gun or edge bander.
* If the edge banding is bubbling or peeling, it may be because the adhesive is not being applied evenly. Apply a thin layer of adhesive to the workpiece and press the edge banding firmly into place.
* If the edge banding is too thick or too thin, it may be difficult to trim. Use a sharp bit and be sure to follow the manufacturer's instructions for your router.

ConclusionEdge banding is a great way to add a finished look to your woodworking projects. By following the steps in this video, you can easily edge band without pre-applied adhesive.

2024-12-17

Previous：Is the Edging Factory Stealing Edging and Panels?

Next：Edge Banding Veneer for On-Site Woodworking: Does It Need Heat?