How to Install a Picture Frame Spline into a Spline Groover235

As a leading manufacturer of Chinese furniture edge banding strips, we are often asked about how to install a picture frame spline into a spline groover. Here's a step-by-step guide to help you get the job done perfectly:

Materials You'll Need:
Picture frame spline
Spline groover
Hammer or mallet
Safety glasses

Step-by-Step Instructions:

1. Wear Safety Glasses:

Always wear safety glasses when working with power tools. This will protect your eyes from flying wood chips or debris.

2. Cut the Spline to Length:

Measure the length of the groove in the picture frame and cut the spline slightly longer than that. It's better to have a little extra spline rather than not enough.

3. Insert the Spline into the Spline Groover:

Hold the spline groover with one hand and the spline in the other. Align the spline with the groove in the spline groover and insert one end of the spline into the groove.

4. Align the Spline Groover with the Frame:

Hold the spline groover against the picture frame, aligning the groove in the spline groover with the groove in the picture frame.

5. Tap the Spline In:

Using a hammer or mallet, gently tap on the back of the spline groover, driving the spline into the groove in the picture frame. Tap evenly along the entire length of the groove.

6. Remove the Spline Groover:

Once the spline is fully seated in the groove, carefully remove the spline groover.

7. Trim the Excess Spline:

Using a sharp knife or utility blade, trim any excess spline that may be sticking out from the edges of the picture frame.

8. Clean Up the Frame:

Use a damp cloth to wipe away any sawdust or debris from the picture frame.

Tips for Installing a Picture Frame Spline:
Use a sharp knife or utility blade to cut the spline. A dull blade will make it difficult to get a clean cut.
Make sure the groove in the spline groover is the correct size for the spline you are using.
Align the spline groover carefully with the groove in the picture frame to avoid making a crooked spline joint.
Tap the spline in gently with a hammer or mallet. Avoid using excessive force, as this could damage the frame or the spline.
Trim the excess spline carefully to avoid cutting into the picture frame.

Conclusion:

Installing a picture frame spline is a relatively simple process, but it's important to follow the steps carefully to ensure a secure and professional-looking result. By following these instructions, you can easily install a spline into your picture frame and protect your artwork for years to come.

2024-12-18

Previous：What‘s the Difference Between Veneer and Edge Banding?

Next：How Much Overlap Should Be Left for Hot Melt Edge Banding?