How to Adjust Edge Banding Length for 368 Automatic Edge Bander53

Introduction

368 automatic edge banders are widely used in furniture manufacturing to apply decorative and functional edge banding to panels. The length of the edge banding strip is a crucial factor that affects the quality and efficiency of the banding process. This article will guide you through the steps on how to adjust the edge banding length for a 368 automatic edge bander.

Step 1: Prepare the Edge Banding

Before adjusting the length, ensure that the edge banding strip is properly prepared. Cut the strip to an approximate length that slightly exceeds the length of the panel you are banding.

Step 2: Check the Initial Setting

On the control panel of the edge bander, locate the setting for edge banding length. Usually, there will be a numerical display or a scale with markings.

Step 3: Measure the Actual Length

Apply a piece of edge banding to a panel and trim it flush with the edge. Measure the actual length of the applied edge banding.

Step 4: Calculate the Difference

Compare the actual length with the initial setting on the edge bander. Calculate the difference between the two values.

Step 5: Adjust the Setting

Based on the calculated difference, adjust the edge banding length setting on the control panel. Typically, there are buttons or knobs for incrementally increasing or decreasing the length.

Step 6: Fine-tune the Adjustment

Apply a new piece of edge banding and trim it. Measure the actual length again. If it still differs from the desired length, repeat steps 3, 4, and 5 to fine-tune the adjustment.

Step 7: Save the Settings

Once you obtain the desired edge banding length, save the settings on the control panel. This will prevent any accidental changes during future operations.

Tips:
Always cut the edge banding strip with a sharp blade to ensure a clean and precise cut.
Inspect the edge banding for any defects or imperfections before applying it.
Use a suitable adhesive that is compatible with both the edge banding and the substrate.
Apply the edge banding evenly and firmly to the edge of the panel.
Trim the excess edge banding flush with the edge of the panel using a sharp utility knife or a trimming tool.

Conclusion

Adjusting the edge banding length for a 368 automatic edge bander requires careful preparation, measurement, and fine-tuning. By following the steps outlined in this article, you can achieve the precise edge banding length required for your furniture manufacturing operations.

2024-12-18

Previous：Which is Better: White Edge Banding or Edge Banding Boards?

Next：How to Edgeband a Cabinet Using Edgebanding Tape