How to Edge a Quarter Round with Eco-Board Edge Banding300

Eco-board edge banding is a popular choice for edging quarter rounds due to its durability, flexibility, and ease of use. Here's a step-by-step guide on how to edge a quarter round with eco-board edge banding:

Materials You'll Need* Eco-board edge banding
* Quarter round molding
* Contact cement
* Utility knife
* Sanding block
* Heat gun or edge bander

Step 1: Prepare the Quarter Round* Cut the quarter round to the desired length.
* Sand any rough edges or splinters to ensure a smooth surface.

Step 2: Apply Contact Cement* Apply a thin layer of contact cement to both the quarter round and the edge banding.
* Allow the cement to dry until it becomes tacky to the touch. This usually takes about 15-20 minutes.

Step 3: Attach the Edge Banding* Align the edge banding with the edge of the quarter round.
* Press the edge banding into place, starting from one end and working your way to the other.
* Use a roller or a burnishing tool to ensure the edge banding adheres securely.

Step 4: Trim the Excess* Once the edge banding is attached, use a utility knife to trim any excess material.
* Be careful not to cut into the quarter round.

Step 5: Heat Shrink (Optional)* If using a heat gun or edge bander, apply heat to the edge banding to shrink it and create a tight bond.
* Hold the heat source about 1-2 inches away from the edge banding and move it along the length of the quarter round.
* Be careful not to overheat the edge banding or it may melt.

Step 6: Sand and Finish* Sand the edge banding flush with the quarter round using a sanding block.
* You can also apply a clear finish, such as lacquer or varnish, to protect the edge banding and enhance its appearance.

Tips* Use a sharp utility knife for clean cuts.
* Apply a consistent pressure when attaching the edge banding to prevent it from bubbling or buckling.
* If the edge banding is slightly too wide, you can sand it down to fit.
* If the edge banding is slightly too narrow, you can apply a thin layer of contact cement to the quarter round before attaching the edge banding.
* Practice on a scrap piece of quarter round before edging the actual pieces.

2024-12-18

Previous：Stainless Steel vs. Plastic Edge Banding: Which One Is Right for Your Furniture?

Next：How Hot Melt Edgebanding Can Ensure Flush Edgebanding