How to Edge Band with Double Sided Edge Banding Tape12

Introduction: Edge banding is an essential part of furniture finishing, and can be done with either hot melt or double sided tape. This guide will provide step-by-step instructions for using double sided tape to edge band your furniture and achieve a professional finish.Materials:
* Double sided edge banding tape
* Edge banding material
* Iron or edge bander
* Trim router or utility knife
* Sanding block or sandpaper
Step 1: Prepare the Edge
* Clean the edge of the substrate thoroughly to remove any dust or debris.
* If the edge is not already square, use a sander or a router to create a straight and flat surface.
Step 2: Apply the Double Sided Tape
* Unroll the edge banding tape and apply it to the edge of the substrate.
* Press the tape down firmly to ensure good adhesion.
Step 3: Heat the Tape
* If using an iron, set it to a medium heat setting.
* Press the iron over the tape, moving in the direction of the grain.
* The heat will activate the adhesive on the tape and create a strong bond.
* If using an edge bander, follow the manufacturer's instructions for setting the temperature and speed.
Step 4: Apply the Edge Banding
* Align the edge banding material with the edge of the substrate and press it down onto the heated tape.
* Use a roller or a block of wood to apply firm pressure and ensure a good bond.
Step 5: Trim the Excess
* Once the edge banding is applied, use a trim router or a utility knife to trim off any excess material.
* Be careful not to cut too deeply into the substrate.
Step 6: Sand the Edge
* Use a sanding block or sandpaper to sand the edge of the banding flush with the surface of the substrate.
* Start with a coarse grit and gradually work up to a finer grit to achieve a smooth finish.
Tips:
* Use a sharp blade when trimming the excess material to avoid tearing the edge banding.
* If the edge banding is too thin, it may not provide sufficient coverage.
* If the edge banding is too thick, it may be difficult to trim and may create a bulky appearance.
* Always test the heat setting on a scrap piece of material before applying it to the actual workpiece.
Conclusion:
Edge banding with double sided tape is a relatively simple and inexpensive way to achieve a professional finish on your furniture. By following these steps, you can easily add a touch of elegance and durability to your projects.

2024-12-18

Previous：Can Edge Banding Machines Handle Wide Edge Bands?

Next：Can ABS Edge Banding Achieve Curved Edges?