How to Edgeband a Wardrobe with T-Molding176

T-molding is a versatile edging solution that can be used to create a seamless and professional-looking finish on the edges of your wardrobe. It is made from a thin strip of material, typically PVC or melamine, with a T-shaped profile. The flat base of the T fits into the rabbet (a groove cut into the edge of the panel), while the flange covers the exposed edge of the panel and creates a clean, finished look.

T-molding is a popular choice for edging wardrobes because it is easy to install, durable, and available in a wide range of colors and finishes to match your décor. It is also a cost-effective solution compared to other edging options.

Materials and Tools Required* T-molding
* Measuring tape
* Pencil or marking knife
* Miter saw or hand saw
* Wood glue
* Nail gun or hammer
* Nails or staples

Step-by-Step Instructions

1. Measure and Cut the T-Molding

* Measure the length of the edge you want to cover with T-molding.
* Transfer the measurements to the T-molding and mark the cut lines with a pencil or marking knife.
* Use a miter saw or hand saw to cut the T-molding to the desired length.

2. Apply Wood Glue to the Rabbet

* Apply a thin layer of wood glue to the rabbet on the edge of the wardrobe.
* Make sure to apply the glue evenly to ensure a strong bond between the T-molding and the panel.

3. Insert the T-Molding into the Rabbet

* Insert the T-molding into the rabbet.
* Gently press the T-molding into place, making sure that it is flush with the surface of the panel.
* Use a rubber mallet to tap the T-molding into place if needed.

4. Nail or Staple the T-Molding

* Once the T-molding is in place, secure it with nails or staples.
* Space the nails or staples about every 6 inches apart.
* Make sure to countersink the nails or staples slightly below the surface of the T-molding.

5. Trim Any Excess T-Molding

* Once the T-molding is secured, trim any excess material that extends beyond the edge of the panel using a utility knife or sharp scissors.

Tips* If you are edging a curved surface, you can use flexible T-molding.
* You can also use double-sided tape to secure the T-molding instead of nails or staples.
* If you are using a miter saw to cut the T-molding, make sure to use a sharp blade for a clean cut.
* Be careful not to apply too much wood glue, as this can cause the T-molding to bulge or warp.
* If you are edging a large or heavy wardrobe, you may need to use additional support, such as clamps or braces, to keep the T-molding in place while it is drying.

2024-12-19

---

Previous：Is It Possible to Edge Band Your Wardrobe Top Yourself?

Next：Are Window Matching Edge Bands a Good Choice?