How to Edge Band an Inside Curve with Furniture Edge Banding86

When it comes to edge banding, there are specific situations that may require a bit more attention. One of those situations is when you need to apply edge banding around an inside curve, such as on a curved tabletop or drawer front. While it may seem like a challenging task, it's actually a fairly straightforward process with the right techniques and tools.

Here's a detailed guide on how to edge band an inside curve using furniture edge banding:

Materials you'll need:

Furniture edge banding of your choice
Edge banding trimmer
Heat gun or edge banding iron
Sharp utility knife
Contact cement or double-sided tape
Sandpaper or sanding block

Step 1: Prepare the surface
Start by cleaning the surface of the workpiece you want to edge band. Ensure it's free from any dirt, dust, or grease. Next, apply a thin layer of contact cement or double-sided tape to the edge of the workpiece, following the manufacturer's instructions.

Step 2: Cut the edge banding
Measure and cut the edge banding to the length required. Make sure to leave a slight overhang at both ends.

Step 3: Apply the edge banding
Place the edge banding over the contact cement or double-sided tape and press it down firmly. Ensure it is aligned correctly and there are no gaps or bubbles.

Step 4: Heat up the edge banding
Now it's time to heat the edge banding to activate the glue. Use a heat gun or edge banding iron and move it along the edge banding, applying heat evenly. As the edge banding heats up, it will start to soften and become more pliable.

Step 5: Use the trimmer
Once the edge banding is heated, use an edge banding trimmer to trim off the excess material. Hold the trimmer against the edge of the workpiece and move it along, carefully trimming off the excess.

Step 6: Sand and finish
Finally, sand down any rough edges using sandpaper or a sanding block. If desired, you can also apply a finishing touch by staining, painting, or applying a topcoat to the edge banding.

Tips for success:

Use a sharp utility knife to ensure a clean and precise cut for the edge banding.
Apply even pressure when heating and trimming the edge banding.
If you encounter any air bubbles during the process, gently prick the bubble with a sharp tool and smooth it out.
Allow sufficient time for the edge banding to cool down before handling it.

By following these steps and using the proper techniques, you can effectively edge band an inside curve on your furniture pieces, giving them a polished and professional finish.

2024-12-19

Previous：How to Seal Edge Trim without an Edge Bander

Next：How to Open Edge Banding Installed by Edge Banding Machine