How to Apply Edge Banding to Cabinets (Video)85

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, MDF, or other wood panels. It is used to create a finished look, protect the edges from moisture and damage, and provide a durable surface that can withstand everyday use. In this video, we will show you how to apply edge banding to cabinets using a hand-held router and an edge banding trimmer.

Materials Needed
Edge banding
Hand-held router
Edge banding trimmer
Router bit
Wood glue
Clamps
Sandpaper

Step-by-Step Instructions1. Prepare the edge of the cabinet by sanding it smooth.
2. Apply a thin layer of wood glue to the edge of the cabinet.
3. Position the edge banding on the edge of the cabinet and clamp it in place.
4. Use the hand-held router to trim the edge banding flush with the surface of the cabinet.
5. Use the edge banding trimmer to round over the edges of the edge banding.
6. Sand the edges of the edge banding smooth.

Tips
Use a router bit that is the same width as the edge banding.
Be careful not to over-trim the edge banding, as this can cause it to chip or break.
Sand the edges of the edge banding smooth to remove any sharp edges.
If you are applying edge banding to a curved surface, use a heat gun to soften the edge banding before applying it.

ConclusionApplying edge banding to cabinets is a relatively simple process that can be completed in a few hours. By following the steps outlined in this video, you can achieve a professional-looking finish that will protect your cabinets from damage and wear.

2024-12-19

Previous：Why Edge Banding is Not Sticking? - Possible Causes and Solutions

Next：How to Install Edge Banding on Cabinet Doors Using an Edge Bander