How to Fold Edge Banding Around Corners314

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, particleboard, or other wood products. It is used to create a finished look and to protect the edge from damage. Edge banding can be made from a variety of materials, including wood, plastic, and metal. The most common type of edge banding is made from PVC (polyvinyl chloride). PVC edge banding is durable, easy to clean, and comes in a variety of colors and finishes.

When applying edge banding, it is important to get a clean, tight fit around the corners. This can be difficult to do, especially if the edge banding is thick or if the corner is sharp. There are a few different techniques that can be used to fold edge banding around corners. The most common technique is the "miter fold." This technique involves cutting the edge banding at a 45-degree angle on both ends. The two pieces of edge banding are then mitered together and glued in place.

Another technique for folding edge banding around corners is the "butt joint." This technique involves cutting the edge banding straight across and then butting the two pieces together. The joint is then glued and clamped in place. The butt joint is not as strong as the miter fold, but it is easier to do.

If you are using thick edge banding, you may need to use a router to create a groove in the edge of the wood. This groove will allow the edge banding to sit flush with the surface of the wood. Once the groove is created, the edge banding can be glued in place.

Here are some tips for folding edge banding around corners:
Use a sharp knife to cut the edge banding.
Make sure the cut is clean and straight.
If you are using the miter fold technique, make sure to cut the edge banding at a 45-degree angle.
Apply a thin layer of glue to the edge of the wood.
Press the edge banding into the glue and hold it in place until the glue dries.
If you are using the butt joint technique, use a clamp to hold the joint together until the glue dries.

Once the glue has dried, you can trim the excess edge banding flush with the surface of the wood.

2024-12-21

Previous：How to Fix Peeling Wood Edging Strips on Chinese Furniture

Next：How to Adjust Edge Banding Trimming on an Edge Banding Machine