How to Repair Cabinet Veneer Edge Banding That Is Lifting197

Cabinet veneer edge banding is a thin strip of wood or other material that is applied to the edges of plywood or MDF to create a finished look. Over time, edge banding can start to lift or peel away from the substrate, which can be unsightly and can also allow moisture to penetrate the wood, causing damage. There are a few different ways to repair lifted edge banding, depending on the severity of the damage.

For minor lifting, you can try using a heat gun or a hair dryer to soften the adhesive and then press the edge banding back into place. Be careful not to overheat the edge banding, as this can damage it. Once the edge banding is in place, you can use a clamp to hold it while the adhesive cools and sets. If the lifting is more severe, you may need to remove the old edge banding and reapply it. To do this, you will need to score the edge banding with a utility knife and then carefully pry it away from the substrate. Once the old edge banding is removed, you can clean the surface of the substrate and apply new edge banding using contact cement.

Here are the steps on how to repair cabinet veneer edge banding that is lifting:1. Gather your materials. You will need a heat gun or hair dryer, a clamp, a utility knife, and contact cement.
2. If the lifting is minor, try using a heat gun or hair dryer to soften the adhesive and then press the edge banding back into place. Be careful not to overheat the edge banding, as this can damage it. Once the edge banding is in place, you can use a clamp to hold it while the adhesive cools and sets.
3. If the lifting is more severe, you may need to remove the old edge banding and reapply it. To do this, you will need to score the edge banding with a utility knife and then carefully pry it away from the substrate. Once the old edge banding is removed, you can clean the surface of the substrate and apply new edge banding using contact cement.
4. To apply new edge banding, first apply a thin layer of contact cement to the edge of the substrate. Then, align the edge banding with the edge of the substrate and press it into place. Use a clamp to hold the edge banding in place while the adhesive dries.

Once the adhesive has dried, you can remove the clamp and enjoy your repaired cabinet!

Additional tips:* If you are using a heat gun to soften the adhesive, be sure to hold it at a distance from the edge banding so that you do not damage it.
* If you are using a hair dryer to soften the adhesive, be sure to use the lowest setting.
* When applying new edge banding, be sure to use a sharp utility knife to score the edge banding. This will help to ensure a clean cut.
* When applying contact cement, be sure to apply a thin, even layer. Too much contact cement can make it difficult to align the edge banding correctly.
* Once the contact cement has been applied, press the edge banding into place quickly and firmly. This will help to ensure a strong bond.

2024-12-22

Previous：How to Get a Clean Edge Finish with Hot Melt Glue Edge Banding

Next：How to Use Edging Banding Trimmer: A Comprehensive Guide