How to Repair Loose and Peeling Edge Banding on Furniture44

Edge banding is a thin strip of material that is applied to the edges of furniture to cover the exposed core and provide a finished look. However, over time, edge banding can become loose and start to peel off, especially if it is not properly installed or if the furniture is exposed to moisture or extreme temperatures. Loose edge banding can not only detract from the appearance of your furniture but also create a safety hazard if it snags on clothing or skin.

Luckily, repairing loose edge banding is a relatively simple process that can be done at home with a few basic tools and materials. Here are the steps on how to repair loose and peeling edge banding:

1. Remove the Loose Edge Banding

Use a sharp utility knife to carefully cut away the loose edge banding. Be careful not to damage the surface of the furniture. If the edge banding is particularly stubborn, you can use a heat gun to soften the adhesive before cutting it away.

2. Clean the Surface

Once the loose edge banding has been removed, clean the surface of the furniture with a damp cloth to remove any dirt or debris. Allow the surface to dry completely.

3. Apply New Adhesive

Apply a thin layer of wood glue or contact cement to the edge of the furniture where the edge banding will be applied. Make sure to use a type of glue that is specifically designed for wood and that is strong enough to hold the edge banding in place.

4. Apply the New Edge Banding

Align the new edge banding with the edge of the furniture and press it into place. Use a rubber mallet or a rolling pin to apply pressure and ensure that the edge banding isしっかりと固定.

5. Trim the Excess Edge Banding

Once the edge banding has been applied, use a sharp utility knife to trim away any excess material. Be careful not to damage the surface of the furniture.

6. Sand and Finish

Sand the edge banding smooth with a fine-grit sandpaper. You can then apply a clear finish to the edge banding to protect it from moisture and wear.

Tips for Preventing Edge Banding from Peeling

Here are a few tips to help prevent edge banding from peeling in the future:
Use a high-quality edge banding material that is specifically designed for furniture.
Make sure the surface of the furniture is clean and dry before applying the edge banding.
Use a strong adhesive that is specifically designed for wood and that is strong enough to hold the edge banding in place.
Apply the edge banding carefully and press it into place firmly.
Trim away any excess edge banding and sand it smooth.
Apply a clear finish to the edge banding to protect it from moisture and wear.

By following these steps, you can easily repair loose and peeling edge banding on your furniture and restore its appearance to its former glory.

2024-12-22

Previous：What Size Edge Banding Radius for Your Furniture?

Next：How to Determine the Correct Edgebander Trimming Knife Size