How to Hand-Edge V-Groove Edging39

V-groove edging is a popular choice for furniture makers because it creates a clean, professional-looking finish. It is also relatively easy to do by hand, making it a good option for beginners. Here are the steps on how to hand-edge V-groove edging:

Materials:
V-groove edging
Wood glue
Clamps
Router
V-groove bit
Router table
Featherboard
Sandpaper

Steps:

1. Prepare the edging

Cut the edging to the desired length. Apply a thin bead of wood glue to the back of the edging, then press it into place on the edge of the workpiece. Use a clamp to hold the edging in place while the glue dries.

2. Route the V-groove

Once the glue is dry, use a router to cut the V-groove. Set up the router table with a V-groove bit. Adjust the bit height so that the tip of the bit is just below the surface of the workpiece. Run the workpiece through the router table, guiding it with a featherboard to prevent kickback.

3. Sand the edges

Once the V-groove is cut, sand the edges of the workpiece to smooth them out. Start with a coarse grit sandpaper and gradually work your way up to a fine grit sandpaper. Be careful not to sand too much, as you don't want to remove the V-groove.

4. Finish the workpiece

Once the edges are sanded, you can finish the workpiece as desired. You can apply a stain or paint, or you can leave it natural. If you are applying a finish, be sure to mask off the V-groove so that the finish doesn't get into it.

Tips:
Use a sharp V-groove bit to get a clean, precise cut.
Make several passes with the router, starting with a shallow cut and gradually deepening it until you reach the desired depth.
Use a featherboard to prevent kickback when routing.
Sand the edges of the workpiece carefully to avoid removing the V-groove.
Mask off the V-groove before applying a finish to prevent the finish from getting into it.

Conclusion:

Hand-edging V-groove edging is a relatively easy process that can be used to create a professional-looking finish on furniture. By following these steps, you can get great results with minimal effort.

2024-12-22

Previous：Ultra-Thin Edge Banding: Is It Worth It?

Next：How to Handle Cracks in Skin Feel Edge Banding after Edging