How to Replace the Edge Banding on a Kitchen Cabinet319

Edge banding is a thin strip of material that is applied to the edges of a kitchen cabinet to cover the exposed core material and protect it from moisture and damage. Over time, edge banding can become damaged or worn, so it may need to be replaced. Replacing the edge banding on a kitchen cabinet is a relatively simple and inexpensive project that can be completed in a few hours.

Materials* New edge banding (matching the thickness and height of the old edge banding)
* Utility knife
* Sandpaper or sanding block
* Contact cement
* Wood glue
* Clamps

Instructions1. Remove the old edge banding. Use a utility knife to carefully score the old edge banding along the top and bottom edges of the cabinet. Be careful not to cut into the wood of the cabinet. Once the edge banding is scored, use a putty knife or a flat-head screwdriver to pry it off of the cabinet.
2. Sand the edges of the cabinet. Once the old edge banding is removed, sand the edges of the cabinet to smooth them out. This will help to ensure that the new edge banding adheres properly.
3. Apply contact cement to the edges of the cabinet and the new edge banding. Use a thin, even coat of contact cement to the edges of the cabinet and the new edge banding. Allow the contact cement to dry for 5-10 minutes, or until it becomes tacky.
4. Apply the new edge banding to the cabinet. Align the new edge banding with the edges of the cabinet and press it into place. Use a roller or a clamp to apply pressure to the edge banding and ensure that it adheres properly.
5. Trim the excess edge banding. Once the edge banding is applied, use a utility knife to trim any excess material.
6. Apply wood glue to the edge banding. Apply a thin, even coat of wood glue to the top and bottom edges of the edge banding. This will help to seal the edge banding and prevent it from peeling off.
7. Clamp the edge banding in place. Use clamps to hold the edge banding in place while the wood glue dries. Allow the wood glue to dry for 24 hours before using the cabinet.

Tips* If you are not sure what type of edge banding to use, you can take a sample of the old edge banding to a hardware store and ask for help.
* When applying the contact cement, be sure to wear gloves and work in a well-ventilated area.
* If you are having trouble getting the edge banding to adhere, you can use a heat gun to soften the contact cement.
* Be careful not to apply too much wood glue, as this can make the edge banding difficult to clean up.

Additional InformationIn addition to the basic instructions above, there are a few additional things to keep in mind when replacing the edge banding on a kitchen cabinet.
* If the cabinet is made of a particularly hard wood, you may need to use a power sander to remove the old edge banding.
* If the cabinet is finished with a high-gloss finish, you may need to use a chemical stripper to remove the old edge banding.
* If the cabinet is exposed to a lot of moisture, you may want to use a waterproof edge banding.
By following these instructions, you can easily replace the edge banding on your kitchen cabinets and give them a fresh, new look.

2024-12-22

Previous：How to Edge Band Ceiling Moldings

Next：How to Sew Garment Bias Tape [Video Tutorial]