Edge Banding Trimming for Reverse Board Installation [Video]103

As a leading manufacturer of edge banding strips in China, we understand the importance of precise and efficient edge banding techniques. One of the most challenging aspects of edge banding is trimming the excess material after the strip has been applied. For reverse board installations, where the edge banding is applied to the back of the board, trimming can be particularly difficult.

In this video, we will demonstrate a simple and effective technique for trimming edge banding on reverse board installations. This technique uses a handheld router with a flush trim bit. The flush trim bit is designed to cut the excess edge banding flush with the surface of the board, resulting in a clean and professional-looking finish.

Materials and Tools Required:* Handheld router
* Flush trim bit
* Safety glasses
* Earplugs
* Dust mask
* Edge banding strip
* Measuring tape
* Pencil

Instructions:1. Prepare the edge banding strip. Measure and cut the edge banding strip to the desired length. Apply the edge banding strip to the back of the board using a hot melt adhesive or double-sided tape.
2. Set up the router. Install the flush trim bit in the handheld router. Adjust the depth of the cut so that the bit is only cutting the excess edge banding material.
3. Trim the edge banding strip. Hold the router firmly against the surface of the board. Start the router and slowly move it along the edge of the board, trimming the excess edge banding material.
4. Inspect the trim. Once you have trimmed the excess edge banding material, inspect the trim to ensure that it is clean and free of any defects. If necessary, use a sanding block or sandpaper to smooth any rough edges.

Tips:* Use a sharp flush trim bit to ensure a clean cut.
* Hold the router firmly against the surface of the board to prevent the bit from bouncing or skipping.
* Move the router slowly and evenly along the edge of the board to achieve a consistent trim.
* Wear safety glasses, earplugs, and a dust mask when trimming edge banding strips.

Conclusion:By following these instructions, you can easily and effectively trim edge banding on reverse board installations. This technique will help you achieve a clean and professional-looking finish that will enhance the appearance of your project.

2024-12-23

Previous：Discover the Ultimate Edge Solution: Dongsheng Nanosame Color High-Quality Edging

Next：The Ultimate Guide to Scraper Blades for Edge Banding