How to Trim Excess Edging Strips in Angled Edging318

Angled edging is a popular technique used in woodworking to create a clean and professional finish on the edges of furniture and other items. It involves applying a thin strip of material, known as an edging strip, to the edge of the workpiece and then trimming away any excess. This process requires precision and care to achieve a seamless result.

One of the key challenges in angled edging is trimming the excess edging strip. If not done properly, the excess material can create unsightly gaps or bumps, compromising the overall appearance of the finished product. In this article, we will guide you through the proper techniques for trimming excess edging strips in angled edging, ensuring a flawless finish.

Tools and Materials

Before you begin, gather the necessary tools and materials:* Edging strip
* Angled edging machine
* Trimmer or utility knife
* Sandpaper or sanding block

Step-by-Step Instructions:

1. Apply the Edging Strip:

Use the angled edging machine to apply the edging strip to the edge of the workpiece. Ensure that the strip is flush with the surface and securely bonded.

2. Cut Off Excess Material:

Once the edging strip is applied, use a sharp trimmer or utility knife to cut off the excess material. Hold the cutting tool at a 45-degree angle to the edge of the workpiece and trim away the excess strip. Be careful not to cut into the workpiece.

3. Sand the Edge:

After trimming, use sandpaper or a sanding block to smooth the edge and remove any rough or uneven surfaces. Sand in the direction of the grain to avoid scratching the workpiece.

4. Check for Gaps:

Inspect the edge carefully for any gaps or voids. If there are any, apply a small amount of wood filler or glue to the gap and sand it smooth once it has dried.

Tips for Trimming Excess Edging Strips:* Use a sharp cutting tool to ensure a clean and precise cut.
* Hold the cutting tool at a 45-degree angle to the edge of the workpiece.
* Trim away the excess material gradually, avoiding cutting too much at once.
* Sand the edge gently and in the direction of the grain.
* If there are any gaps, fill them with wood filler or glue before sanding.

Conclusion:

By following these steps and tips, you can effectively trim excess edging strips in angled edging and achieve a professional-looking finish. With practice, you will become more proficient in this technique, enhancing the durability and aesthetic appeal of your woodworking projects.

2024-12-23

Previous：How to Use an Electric Trimmer for Edge Banding

Next：Bridging the Gap: Aluminum Extrusions – To Glue or to Tape?