How to Trim Edge Banding with a Flush Trim Router Bit269

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, particleboard, or MDF. It is used to give the piece a finished look and to protect the edges from moisture and damage. Edge banding can be applied using a variety of methods, but one of the most common is to use a flush trim router bit.

A flush trim router bit is a router bit that has a bearing that rides along the edge of the workpiece. This bearing ensures that the bit cuts flush with the surface of the workpiece, leaving a clean, finished edge. Flush trim router bits are available in a variety of sizes and shapes, so you can choose the one that is best suited for your project.

To trim edge banding with a flush trim router bit, you will need the following tools and materials:
A router
A flush trim router bit
Edge banding
Contact cement
A utility knife
A sanding block

Once you have gathered your tools and materials, you can follow these steps to trim edge banding with a flush trim router bit:
Apply contact cement to the edge of the workpiece and to the back of the edge banding. Allow the contact cement to dry for a few minutes, until it becomes tacky.
Align the edge banding with the edge of the workpiece and press it into place. Use a roller or a burnishing tool to apply pressure to the edge banding and ensure that it isしっかりと付着している.
Set up your router with the flush trim router bit. Adjust the bit so that it is flush with the surface of the workpiece.
Trim the edge banding by routing along the edge of the workpiece. Hold the router steady and move it at a consistent speed.
Once you have trimmed the edge banding, sand the edges of the workpiece to smooth them out.

With a little practice, you can use a flush trim router bit to trim edge banding quickly and easily. This is a great way to give your projects a professional-looking finish.

Tips for Trimming Edge Banding
Use a sharp router bit. A dull bit will tear the edge banding and leave a rough finish.
Set the router bit to the correct depth. The bit should be flush with the surface of the workpiece.
Hold the router steady and move it at a consistent speed. If you move the router too quickly, the bit will tear the edge banding.
If you are trimming a long piece of edge banding, make sure to support the workpiece so that it does not sag.
Once you have trimmed the edge banding, sand the edges of the workpiece to smooth them out.

2024-12-23

Previous：Why Does the Edge Banding Break When Edging?

Next：[Solved] Why Does My PVC Edge Banding Turn White After Trimming?