How to Trim Edge Banding with a Trimmer296

Edge banding is a great way to hide exposed edges on plywood, particleboard, and other building materials. It gives your project a clean, finished look and it's easy to do with a trimmer. Here's a step-by-step guide on how to trim edge banding with a trimmer.

Step 1: Gather your tools and materials.

You will need:
- A trimmer
- A flush trim bit
- Edge banding
- Wood glue
- A sanding block
- Sandpaper

Step 2: Prepare the edge banding.

Cut the edge banding to the length of the edge you are trimming. Apply a thin layer of wood glue to the back of the edge banding.

Step 3: Align the edge banding.

Place the edge banding on the edge of the board. Use a straight edge to align the banding so that it's flush with the edge of the board.

Step 4: Trim the edge banding.

Insert the flush trim bit into the trimmer. Hold the trimmer against the edge of the board so that the bit is touching the edge banding. Turn on the trimmer and slowly move it along the edge of the board. The bit will trim the edge banding flush with the surface of the board.

Step 5: Sand the edge banding.

After trimming the edge banding, sand the edges of the banding to smooth them out. Use a sanding block and sandpaper to sand the edges until they are flush with the surface of the board.

Tips:

- Use a sharp bit to get a clean cut.
- Be careful not to push the trimmer too quickly, as this can cause the bit to burn the edge banding.
- If you are trimming a long edge, use a guide to help you keep the trimmer straight.
- Wear safety glasses when using a trimmer.

Conclusion:

Trimming edge banding with a trimmer is a quick and easy way to give your project a clean, finished look. By following the steps in this guide, you can get professional results even if you're a beginner.

2024-12-23

Previous：How to Edge Band Cabinets Like a Pro: A Step-by-Step Guide for Woodworkers

Next：How to Edge Band a Flower Stand Border: A Video Demonstration