How to Adjust the Height and Inclination of the 750 Edge Banding Machine‘s Pressure Beam250

Are you having trouble getting perfect edges on your banded panels? The height and inclination of your pressure beam may be off. This beam presses the banding material onto the panel, and if it's not set correctly, you'll end up with gaps or overlaps. Here's a step-by-step guide on how to adjust the height and inclination of the pressure beam on a 750 edge banding machine:

Adjusting the Height of the Pressure Beam

1. Loosen the bolts that hold the pressure beam in place.
2. Use a wrench or Allen key to turn the adjustment screw. Turning the screw clockwise will raise the pressure beam, while turning it counterclockwise will lower it.
3. Once you have the desired height, tighten the bolts to secure the pressure beam in place.

Adjusting the Inclination of the Pressure Beam

1. Loosen the bolts that hold the pressure beam in place.
2. Use a wrench or Allen key to turn the adjustment screw. Turning the screw clockwise will increase the inclination of the pressure beam, while turning it counterclockwise will decrease it.
3. Once you have the desired inclination, tighten the bolts to secure the pressure beam in place.

Tips

Here are a few tips to help you get the most out of your 750 edge banding machine:
Make sure that the pressure beam is level before you start edging. This will help to ensure that the banding material is applied evenly.
Use the correct amount of pressure. Too much pressure can damage the banding material, while too little pressure will not hold it securely in place.
Clean the pressure beam regularly to remove any dust or debris. This will help to prevent the beam from sticking to the banding material.

By following these steps, you can adjust the height and inclination of the pressure beam on your 750 edge banding machine to get perfect edges every time.

2024-12-23

Previous：Which Is Better: Veneer Edge Banding or Laminate Edging?

Next：How to Edge Band Curved Wooden Boards: A Comprehensive Guide for Finishing Door Jambs