How Wide Should Edge Banding Be for 45 Degree Cabinet Doors?383

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, MDF, or particle board. It serves both a functional and aesthetic purpose. Functionally, edge banding helps to protect the core material from moisture and wear. Aesthetically, it can improve the appearance of the finished product by providing a clean, finished edge.

When it comes to 45 degree cabinet doors, the width of the edge banding is important. The edge banding should be wide enough to cover the entire edge of the door, including the mitered joint. If the edge banding is too narrow, it will not provide adequate protection for the door and may also look unfinished.

As a general rule of thumb, the width of the edge banding should be equal to or slightly wider than the thickness of the door. For example, if you have a 3/4-inch thick door, you should use edge banding that is at least 3/4-inch wide.

In addition to the width of the edge banding, you also need to consider the thickness. The thickness of the edge banding should be sufficient to provide adequate protection for the door, but it should not be so thick that it is difficult to work with.

As a general rule of thumb, the thickness of the edge banding should be between .020 and .060 inches. This thickness range provides a good balance between protection and ease of use.

When choosing the right edge banding for your 45 degree cabinet doors, it is important to consider both the width and the thickness. By following the guidelines outlined above, you can choose the right edge banding that will provide both protection and aesthetic appeal.

Here are some additional tips for choosing and applying edge banding to 45 degree cabinet doors:

Use a high-quality edge banding that is made from a durable material, such as PVC or ABS.
Make sure the edge banding is wide enough to cover the entire edge of the door, including the mitered joint.
Choose a color and finish for the edge banding that complements the door.
Apply the edge banding using a hot iron or a heat gun.
Trim the excess edge banding using a sharp utility knife.

2024-12-23

---

Previous：How to Use Aluminum Edge Banding for Edging Wood Panels

Next：Why Edge Banding is Loose?