How Much Wood Veneer Edge Banding to Leave Overhang317

When applying wood veneer edge banding to your project, it is important to leave a slight overhang on the edges. This will help to ensure a strong and durable bond between the banding and the substrate. The amount of overhang you leave will depend on the thickness of the banding and the substrate, as well as the type of adhesive you are using. In general, you should leave about 1/16 inch of overhang on each side of the banding.

To apply the edge banding, first cut the banding to the desired length. Then, apply a thin layer of adhesive to the back of the banding and to the edge of the substrate. Next, align the banding with the edge of the substrate and press it into place. Use a roller or a burnishing tool to press the banding firmly into place and remove any air bubbles. Finally, trim the excess banding flush with the edge of the substrate using a sharp knife or a flush trim bit.

If you are using a hot melt adhesive, you will need to heat the adhesive before applying it to the banding and the substrate. You can do this using a heat gun or a hot melt glue gun. Once the adhesive is heated, apply it to the banding and the substrate and press the banding into place. Hold the banding in place for a few seconds to allow the adhesive to cool and set.

Once the edge banding is applied, you can finish it to match the rest of your project. You can paint it, stain it, or apply a clear finish. If you are painting or staining the edge banding, be sure to sand it lightly before applying the finish. This will help the finish to adhere better to the banding.

Here are some additional tips for applying wood veneer edge banding:
Use a sharp knife or a flush trim bit to trim the excess banding. A dull knife will tear the banding and leave a rough edge.
Sand the edge banding lightly before applying a finish. This will help the finish to adhere better to the banding.
Apply multiple thin coats of finish to the edge banding. This will help to build up the finish and protect the banding from wear and tear.

2024-12-27

Previous：How to Install Freezer Edge Banding

Next：How to Fix Split Woodworking Edgebanding