How to Replace Edge Banding on Wood Boards195

Edge banding is a thin strip of material that is applied to the edges of wood boards to conceal the raw edges and protect them from damage. Over time, edge banding can become damaged, chipped, or worn, requiring replacement. Replacing edge banding is a relatively simple DIY project that can be completed with a few basic tools and materials.

Materials You'll Need:* New edge banding
* Iron or edge bander
* Trimming tool (utility knife, flush trim saw, or router)
* Sandpaper or sanding block
* Wood glue (optional)

Steps to Replace Edge Banding on Wood Boards:

Step 1: Remove the Old Edge Banding

* Using a utility knife or flush trim saw, carefully remove the old edge banding from the wood board.
* If the old edge banding is particularly stubborn, you can use a heat gun or hair dryer to soften the adhesive. Be careful not to overheat the wood.

Step 2: Prepare the Surface

* Sand the edges of the wood board to remove any remaining adhesive or debris.
* If desired, you can apply a thin layer of wood glue to the edges of the board to ensure a secure bond.

Step 3: Apply the New Edge Banding

* Cut the new edge banding to the appropriate length.
* If using an iron, heat the edge banding and apply it to the edge of the board. Hold it in place until the adhesive has cooled and set.
* If using an edge bander, follow the manufacturer's instructions to apply the edge banding.

Step 4: Trim and Sand

* Once the edge banding is applied, use a trimming tool to remove any excess material.
* Sand the edges of the edge banding until they are flush with the surface of the wood board.

Tips for Replacing Edge Banding:* Use a thin layer of wood glue to ensure a secure bond.
* If using an iron, be careful not to overheat the edge banding or the wood.
* Use a sharp trimming tool to achieve a clean, professional finish.
* If desired, you can apply a finish, such as paint or varnish, to the edge banding to match the surrounding wood.
By following these steps, you can easily replace edge banding on wood boards and restore their clean and finished appearance.

2025-01-04

---

Previous：Are Factory-Applied Edge Bands a Good Choice?

Next：How Edgebanding Helps with Thermal Insulation