How to Change Edge Banding on an Edge Banding Machine342

Edge banding is an essential part of furniture making, as it helps to protect the edges of the wood from damage and moisture. It also gives the furniture a more finished and professional look. If you're using an edge banding machine, it's important to know how to change the edge banding when it runs out. Here's a step-by-step guide:

1. Turn off the machine and unplug it. This is for safety reasons, as the machine can be dangerous if it's running while you're working on it.

2. Remove the old edge banding. To do this, simply lift the edge banding up from the edge of the wood. It should come off easily.

3. Clean the edge of the wood. This will help the new edge banding adhere properly. You can use a damp cloth or a tack cloth to remove any dust or dirt.

4. Apply the new edge banding. Start by applying a thin layer of glue to the edge of the wood. Then, press the edge banding into the glue and hold it in place for a few minutes. You can use a rubber mallet to help you apply pressure.

5. Trim the excess edge banding. Once the glue has dried, you can use a utility knife to trim the excess edge banding. Be careful not to cut into the wood.

6. Sand the edge banding. This will help to smooth out any rough edges and give the furniture a more finished look.

7. Plug in the machine and turn it on. You're now ready to start using your edge banding machine again.

Here are some additional tips for changing edge banding on an edge banding machine:
Make sure that the edge banding is the right size for the machine. It should be wide enough to cover the edge of the wood, but not so wide that it overlaps.
If the edge banding is too thick, it may not adhere properly. You can sand it down to make it thinner.
If the edge banding is too thin, it may not be strong enough to protect the edge of the wood. You can use a double layer of edge banding to make it stronger.
Be careful not to apply too much glue. If the glue gets on the wood, it can be difficult to remove.
Hold the edge banding in place for a few minutes while the glue dries. This will help the edge banding adhere properly.
Trim the excess edge banding carefully. Be careful not to cut into the wood.
Sand the edge banding to smooth out any rough edges.

By following these steps, you can easily change the edge banding on your edge banding machine. With a little practice, you'll be able to do it quickly and efficiently.

2025-01-05

Previous：What to Expect from Wallpaper Bordering

Next：What is Double-Sided Edge Banding?