How to Replace Cabinet Door Edge Banding218

Replacing cabinet door edge banding is a relatively simple project that can be completed in a few hours. With the right tools and materials, you can give your cabinets a fresh, updated look in no time.

Tools and Materials You'll Need* Utility knife
* Measuring tape
* Pencil
* Wood filler
* Sandpaper
* Edge banding
* Iron
* Iron-on adhesive
* Trim router
* Flush trim bit

Step-by-Step Instructions

Step 1: Remove the old edge banding. Using a utility knife, carefully score the old edge banding along the edge of the cabinet door. Be careful not to damage the cabinet door itself.

Step 2: Clean the surface. Once the old edge banding has been removed, clean the surface of the cabinet door with a damp cloth. This will remove any dust or debris that could interfere with the adhesion of the new edge banding.

Step 3: Apply wood filler. Fill in any gaps or imperfections in the surface of the cabinet door with wood filler. Let the wood filler dry completely before proceeding.

Step 4: Sand the surface. Once the wood filler is dry, sand the surface of the cabinet door until it is smooth and even. This will help to ensure a good bond between the new edge banding and the cabinet door.

Step 5: Measure and cut the edge banding. Measure the length of the edge of the cabinet door and cut the edge banding to the same length. Allow for a slight overlap at each end.

Step 6: Apply iron-on adhesive. Apply a thin layer of iron-on adhesive to the back of the edge banding. Be sure to follow the manufacturer's instructions.

Step 7: Iron on the edge banding. Place the edge banding on the edge of the cabinet door and press it down with a hot iron. Hold the iron in place for several seconds to allow the adhesive to bond. Trim any excess edge banding with a utility knife.

Step 8: Trim the edge banding. Use a trim router fitted with a flush trim bit to trim the edge banding flush with the surface of the cabinet door. This will give the edge banding a professional, finished look.

Tips for Success* Use a sharp utility knife to score the old edge banding. This will help to prevent tearing and splintering.
* Clean the surface of the cabinet door thoroughly before applying the new edge banding. This will help to ensure a good bond.
* Apply a thin layer of iron-on adhesive to the back of the edge banding. Too much adhesive can make it difficult to apply the edge banding and can cause it to bubble.
* Hold the iron in place for several seconds when ironing on the edge banding. This will allow the adhesive to bond properly.
* Trim the edge banding flush with the surface of the cabinet door using a trim router. This will give the edge banding a professional, finished look.

2025-01-10

Previous：How to Sew Sleeve Edging Strips

Next：How Furniture Edge Banding is Made