How to Edge Band an Arced Tabletop: A Step-by-Step Guide59

Edge banding is an essential step in furniture making, as it provides a finished and professional look to the piece. When it comes to curved or arced tabletops, edge banding can be a bit more challenging, but it is still possible to achieve a great result with the right tools and techniques.

In this guide, we will walk you through the steps on how to edge band an arced tabletop using a manual edge bander. We will also provide some tips and tricks to help you get the best possible results.

Materials you'll need:* Arced tabletop
* Edge banding material (matching the tabletop thickness)
* Manual edge bander
* Hot melt glue
* Trimming router
* Flush trim bit
* Sandpaper

Step 1: Prepare the tabletop and edge banding* Start by sanding the edge of the tabletop to remove any splinters or rough spots.
* Cut the edge banding to the length of the tabletop, plus a few extra inches.
* Apply a thin layer of hot melt glue to the back of the edge banding.

Step 2: Apply the edge banding* Align the edge banding with the edge of the tabletop.
* Press the edge banding firmly into place, using a rolling pin or a J-roller.
* Hold the edge banding in place for a few minutes to allow the glue to set.

Step 3: Trim the excess edge banding* Use a trimming router to trim the excess edge banding flush with the surface of the tabletop.
* Be sure to use a flush trim bit that is the same diameter as the edge banding.

Step 4: Sand the edge banding* Sand the edge banding to smooth out any rough edges.
* Start with a coarse grit sandpaper and gradually work your way up to a finer grit.

Tips and tricks:* Use a sharp blade to cut the edge banding. This will help to prevent the edge banding from chipping or tearing.
* If you are having trouble getting the edge banding to stick, you can use a heat gun to soften the glue.
* Be careful not to apply too much pressure when trimming the edge banding. This can cause the edge banding to crack or break.
* If you are working with a very long tabletop, you may want to use a power edge bander. This will make the process much faster and easier.

With a little practice, you can edge band an arced tabletop like a pro. Just follow the steps in this guide and you will be sure to get great results.

2025-01-13

Previous：How to Make Your Own Edge Banding: A Step-by-Step Guide

Next：How to Install Edge Banding on Suspended Indoor Ceilings