Retro Small Edging, How to Edge It49

Retro edging strips, mainly for edge sealing of furniture and other panels, have the characteristics of environmental protection, long service life, good adhesion, smooth surface, etc. They are mainly used to cover the exposed edges of various boards, so as to achieve the sealing effect, reduce the damage caused by external factors to the board, protect the interior of the board from damage, and increase the service life of the board.

The operation steps of retro small edging strip are not complicated. The specific operation steps are as follows:1. Surface treatment

Before pasting the retro small edging strip, the surface of the board should be cleaned to remove dust, oil stains and other impurities on the surface of the board. A clean surface can ensure the adhesion of the retro edging strip.2. Coating glue

Apply glue evenly to the surface of the board or the back of the retro edging strip. The selected glue should have a strong bonding force and can be used in the environment where the board is located.3. Paste the edging strip

Align the retro small edging strip with the edge of the board and paste it. When pasting, press the edging strip firmly to make it fully bonded to the board, and at the same time pay attention to the alignment of the edging strip to ensure the aesthetics.4. Trim the edging strip

After the retro small edging strip is pasted, if there are protruding parts or uneven parts, they can be trimmed with a utility knife or an edging knife to make the edge of the board smooth and flat.5. Clean up

After the retro small edging strip is pasted, the excess glue on the surface of the board or the edge of the edging strip should be cleaned up to ensure the aesthetics.

In addition to the above steps, there are a few points that need to be paid attention to when pasting the retro small edging strip.1. Choose the right edging strip

Different edging strips have different materials, colors, sizes, etc., which need to be selected according to the actual use environment and personal preference.2. Pay attention to the quantity and proportion of glue

The amount and proportion of glue should be appropriate. If the amount of glue is too small, it will affect the adhesion of the edging strip, and if the amount of glue is too large, it will
cause waste.3. Control the pasting time and strength

When pasting the edging strip, the time should be controlled within a proper range, and the strength should not be too large, so as not to damage the edging strip or the board.4. Handle with care after pasting

After pasting the edging strip, it should be handled with care, and the cured glue should not be subjected to external force to avoid degumming.

By following the above steps and precautions, you can paste the retro small edging strip by yourself, which will not only protect the board, but also increase the aesthetics of the board.

2025-01-14

Previous：How to Apply Iron-On Hemming Tape

Next：Why Our Edge Banding Outshines the Competition