How to Remove Edging Strips from Wooden Cabinets and Drawers98

Introduction

Edging strips, also known as edge banding, are thin strips of material that are applied to the edges of wooden cabinets and drawers to provide a finished look and protect the edges from damage. Over time, edging strips may become loose or damaged and need to be replaced. Here is a step-by-step guide on how to remove edging strips from wooden cabinets and drawers.

Tools and Materials

Before you begin, you will need the following tools and materials:
Putty knife or thin screwdriver
Hammer
Nail puller
New edging strips (if necessary)
Wood glue
Clamps

Step-by-Step Instructions

Follow these steps to remove edging strips from wooden cabinets and drawers:
Remove the hardware. Start by removing any hardware, such as handles or knobs, from the cabinet or drawer.
Score the edge of the edging strip. Use a putty knife or thin screwdriver to score the edge of the edging strip where it meets the wood. This will help to loosen the glue and make it easier to remove.
Insert the putty knife. Insert the putty knife or screwdriver under the scored edge of the edging strip and gently pry it up. Be careful not to damage the wood.
Remove the edging strip. Once you have pried up the edge of the edging strip, you can use a hammer and nail puller to remove the nails that are holding it in place. Be careful not to damage the wood.
Clean the edges. Once the edging strip is removed, clean the edges of the wood with a damp cloth to remove any glue or debris.
Apply new edging strips (optional). If you are replacing the edging strips, apply a thin layer of wood glue to the edges of the wood and press the new edging strips into place. Clamp the edging strips in place and allow the glue to dry completely.
Reattach the hardware. Once the glue is dry, you can reattach the hardware to the cabinet or drawer.

Tips
If the edging strips are particularly difficult to remove, you may need to use a heat gun to soften the glue. Be careful not to overheat the wood.
If you are replacing the edging strips, make sure that the new edging strips are the same thickness and width as the old edging strips. This will ensure a flush fit.
If you are having trouble removing the edging strips, you may want to seek the help of a professional.

Conclusion

Removing edging strips from wooden cabinets and drawers is a relatively simple task that can be completed in a few hours. By following the steps outlined in this guide, you can safely remove the old edging strips and replace them with new ones. This will give your cabinets and drawers a fresh, updated look.

2024-10-04

Previous：What Type of Edge Banding Should You Use for Particleboard Cabinet Doors?

Next：How to Apply White Mirror Gloss Sealer Strip