How to Iron Wood Veneer Edge Banding226

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, MDF, or other wood panels. It is used to cover the raw edge of the panel and give it a more finished look. Edge banding can be made from a variety of materials, including wood, plastic, and metal. In this article, we will discuss how to iron wood veneer edge banding.

Wood veneer edge banding is a thin layer of real wood that is bonded to a backing material. It is a popular choice for edge banding because it provides a natural wood look and feel. Wood veneer edge banding is available in a variety of wood species, so you can choose the one that best matches your project.

To iron wood veneer edge banding, you will need the following tools and materials:
Wood veneer edge banding
Iron
Ironing board
Damp cloth
Adhesive
Trimmer

Instructions:
Place the edge banding on the ironing board with the adhesive side facing up.
Cover the edge banding with a damp cloth.
Set the iron to the "wool" or "silk" setting.
Iron the edge banding for 10-15 seconds, or until the adhesive has melted and the edge banding is bonded to the panel.
Remove the damp cloth and allow the edge banding to cool.
Trim the excess edge banding with a trimmer.

Here are some additional tips for ironing wood veneer edge banding:
Use a sharp iron to avoid snagging the edge banding.
Do not iron the edge banding for too long, or the adhesive will burn and the edge banding will be damaged.
If the edge banding is not bonding properly, you can apply additional adhesive to the back of the edge banding before ironing.
Once the edge banding has been ironed on, you can sand it lightly to smooth the edges.

Ironing wood veneer edge banding is a relatively simple process, but it does require some practice to get the hang of it. With a little patience, you can achieve professional-looking results.

2025-01-18

Previous：How to Repair Scratches on Furniture Edging Strips: A Comprehensive Guide

Next：What Is the Ideal Width for Door Edge Banding?