How to Pull a Metal Edge Banding308

Metal edge banding is a stylish and durable way to finish the edges of your furniture. It is available in a variety of finishes, including brushed aluminum, stainless steel, and brass. Metal edge banding can be applied to any type of furniture, from cabinets to tables to desks.

To pull a metal edge banding, you will need the following tools:* A metal edge banding machine
* A router
* A flush trim bit
* A hammer
* A nail set
* A sanding block
* A tack cloth

Once you have gathered your tools, you can begin the process of pulling a metal edge banding.

Step 1: Prepare the edge of the furniture

The first step is to prepare the edge of the furniture. This involves removing any old edging or finish. You can do this with a router or a hand saw.

Once the edge is clean, you need to apply a thin layer of glue to the edge. You can use a brush or a roller to apply the glue.

Step 2: Apply the metal edge banding

Next, you need to apply the metal edge banding to the edge of the furniture. Start by aligning the edge banding with the edge of the furniture. Then, press the edge banding firmly into place.

You may need to use a hammer and a nail set to secure the edge banding in place. Be careful not to hit the edge banding too hard, or you could damage it.

Step 3: Trim the edge banding

Once the edge banding is in place, you need to trim it flush with the edge of the furniture. You can do this with a router or a hand saw.

If you are using a router, be sure to use a flush trim bit. This will help you to get a clean, even cut.

Step 4: Sand the edge banding

Finally, you need to sand the edge banding to smooth it out. You can use a sanding block or a handheld sander.

Be sure to sand the edge banding in the direction of the grain. This will help to prevent the edge banding from chipping or peeling.

Step 5: Clean the edge banding

Once the edge banding is sanded, you need to clean it with a tack cloth. This will remove any dust or debris from the edge banding.

Your metal edge banding is now complete!

Here are some additional tips for pulling a metal edge banding:* Use a sharp router bit. A dull router bit will tear the edge banding.
* Be careful not to press the edge banding too hard into place. This could damage the edge banding.
* Trim the edge banding flush with the edge of the furniture. This will help to prevent the edge banding from peeling or chipping.
* Sand the edge banding in the direction of the grain. This will help to prevent the edge banding from chipping or peeling.
* Clean the edge banding with a tack cloth. This will remove any dust or debris from the edge banding.

2025-01-25

Previous：How to Connect Edge Banding Pipes: A Comprehensive Guide for Furniture Manufacturers

Next：Which Type of Wood Veneer Edge Banding is the Best?