How to Replace Edge Banding358

Edge banding is a thin strip of material that is applied to the exposed edges of plywood, particleboard, or MDF to give it a finished look. Over time, edge banding can become damaged or worn, and it may need to be replaced. Replacing edge banding is a relatively simple process that can be done with a few basic tools.

Here are the steps on how to replace edge banding:
Remove the old edge banding. To remove the old edge banding, you will need to use a utility knife or a sharp chisel. Carefully score the edge banding along the entire length of the edge, and then use a putty knife or a pry bar to remove it.
Clean the edge. Once the old edge banding has been removed, you will need to clean the edge of the wood. Use a damp cloth to remove any dirt or debris, and then allow the edge to dry completely.
Apply the new edge banding. To apply the new edge banding, you will need to use a contact cement. Apply a thin layer of contact cement to the edge of the wood, and then align the new edge banding with the edge. Press the edge banding firmly into place, and use a roller or a hammer to ensure that it is securely attached.
Trim the excess edge banding. Once the edge banding has been applied, you will need to trim the excess. Use a sharp utility knife or a miter saw to trim the edge banding flush with the edge of the wood.
Sand the edge. To finish the process, you will need to sand the edge of the wood. Use a fine-grit sandpaper to sand the edge smooth, and then wipe it clean with a damp cloth.

Replacing edge banding is a simple process that can be done with a few basic tools. By following these steps, you can easily give your furniture a new finished look.

2025-01-26

Previous：How to Calculate Edgebanding Costs for Chinese Furniture Manufacturers

Next：Is Hot Melt Glue Necessary for Edge Banding and Moulding?