How to Adjust the Edgebanding Allowance388

As a leading manufacturer of edgebanding strips in China, we are often asked about how to adjust the edgebanding allowance. This is an important question, as the correct allowance will ensure that your edgebanding is applied smoothly and securely.

There are two main factors to consider when adjusting the edgebanding allowance: the thickness of the substrate and the width of the edgebanding strip. The thicker the substrate, the greater the allowance should be. This is because the thicker the substrate, the more the edgebanding strip will need to be stretched to fit around it.

The width of the edgebanding strip should also be taken into account when adjusting the allowance. The wider the strip, the greater the allowance should be. This is because the wider the strip, the more it will need to be folded over the edge of the substrate.

In general, a good starting point for the edgebanding allowance is 1/16 inch. However, this may need to be adjusted depending on the specific materials you are using.

To adjust the edgebanding allowance, follow these steps:1. Loosen the tension knob on the edgebanding machine.
2. Move the fence to the desired position.
3. Tighten the tension knob.
4. Test the allowance by applying a few pieces of edgebanding to the substrate.
5. Make any necessary adjustments.

Once you have adjusted the edgebanding allowance, you can begin applying the edgebanding to your substrate. It is important to apply the edgebanding evenly and securely to ensure a professional-looking finish.

Here are some additional tips for adjusting the edgebanding allowance:* If you are using a thin substrate, you may need to use a smaller allowance.
* If you are using a wide edgebanding strip, you may need to use a larger allowance.
* If you are applying the edgebanding by hand, you may need to use a larger allowance.
* It is always a good idea to test the allowance before applying the edgebanding to the entire substrate.
By following these tips, you can ensure that your edgebanding is applied smoothly and securely.

2025-02-03

Previous：Why is the Automatic Profile Wrapping Machine Not Conveying the Edge Banding?

Next：How to Join Edge Banding Strips: Top and Bottom Techniques