How to Edge Band with 6mm Strips44

Edge banding is an essential step in furniture making, as it gives the piece a finished look and protects the edges from damage. There are a variety of edge banding materials and methods available, but one of the most common is using 6mm strips. In this article, we will provide a step-by-step guide on how to edge band with 6mm strips, ensuring a professional-looking finish.

Materials and Tools Needed:* 6mm edge banding strips
* Hot melt glue
* Edge bander machine
* Trimmer
* Sandpaper or sanding block

Step 1: Prepare the Edge* Clean and sand the edge of the workpiece to remove any dirt or debris.
* If necessary, apply a thin layer of hot melt glue to the edge and let it cool. This will help the edge banding adhere better.

Step 2: Apply the Hot Melt Glue* Heat up the hot melt glue in the glue pot of the edge bander machine.
* Adjust the glue flow rate to a medium setting.

Step 3: Feed the Edge Banding Strip* Insert the 6mm edge banding strip into the feed slot of the edge bander machine.
* Make sure the strip is properly aligned and guided into the glue path.

Step 4: Apply the Edge Banding* Turn on the edge bander machine and guide the workpiece slowly along the feed table.
* As the workpiece passes through the machine, the hot melt glue will be applied to the edge and the edge banding strip will be bonded in place.

Step 5: Trim the Excess Edge Banding* Once the edge banding is applied, use a trimmer to cut off the excess material at the ends of the workpiece.
* Be careful not to cut into the workpiece itself.

Step 6: Sand the Edge Banding* Sand the edge banding flush with the surface of the workpiece using sandpaper or a sanding block.
* Start with a coarse grit sandpaper and gradually move to a finer grit until the edge banding is smooth and seamless.

Tips for Success:* Use a sharp trimmer blade to prevent tearing the edge banding.
* If the hot melt glue is too hot, it can scorch the edge banding.
* If the hot melt glue is not hot enough, it will not adhere properly.
* Apply light pressure when trimming the excess edge banding to avoid damaging the workpiece.
* Sanding the edge banding in the direction of the grain will help achieve a smoother finish.
By following these steps, you can achieve professional-looking edge banding with 6mm strips, enhancing the durability and aesthetics of your furniture pieces.

2025-02-05

Previous：Car Edge Trim: Is It Worth the Cost?

Next：How to Distinguish ABS Edge Banding