How to Cut Column Edge Banding174

Column edge banding is a decorative and functional strip used to cover the exposed edges of columns and other rounded surfaces. It provides a clean and finished look to your projects while protecting the wood from damage. Cutting column edge banding requires a bit more precision than cutting straight edge banding, but with the right tools and techniques, you can achieve professional-looking results.

Tools you'll need:
Column edge banding
Column notching tool
Mitre saw or hand saw
Tape measure or ruler
Safety goggles

Step 1: Measure and mark the length of the banding

Measure the circumference of the column where you want to apply the edge banding. Add about 1-2 inches to the measurement to allow for overlap. Transfer the measurement to the edge banding and use a pencil to mark the cutting line.

Step 2: Notch the banding

Use a column notching tool to create notches in the edge banding. The notches should be about 1/4 inch wide and 1/8 inch deep. The spacing between the notches depends on the diameter of the column and the type of edge banding you are using. For most columns, notches spaced about 2-3 inches apart are sufficient.

Step 3: Cut the banding

Place the edge banding on a flat surface and align the cutting line with the blade of a mitre saw or hand saw. Wear safety goggles and hold the banding securely with your non-dominant hand. Slowly cut the banding along the marked line.

Step 4: Fit the banding to the column

Apply a thin layer of wood glue to the exposed edge of the column. Position the edge banding on the column and slowly wrap it around, aligning the notches with the curves of the column. Use your fingers or a rubber mallet to gently press the banding into place.

Step 5: Trim the excess

Once the banding is wrapped around the column, trim any excess overhanging the edges. Use a sharp utility knife or chisel to carefully trim the excess flush with the surface of the column.

Step 6: Sand and finish

Sand the edge of the banding slightly to smooth out any rough edges or imperfections. You can apply a coat of wood stain, paint, or clear finish to match the color and finish of your project.

Tips:
Use a sharp blade for cutting the edge banding. A dull blade will create ragged edges and make it more difficult to get a clean cut.
Practice on a scrap piece of wood before cutting the actual banding.
If you are not comfortable using a mitre saw, you can cut the banding by hand using a sharp utility knife or chisel.
Be patient and take your time. Cutting column edge banding requires precision and attention to detail.

2025-02-06

Previous：Why Manufacturers Beware of White Lines on Edge Banding?

Next：Wood Edge Banding vs. T-molding: Which is Right for Your Project?