How to Apply Edge Banding Perfectly on Right Angles314

Applying edge banding on right angles can be a bit tricky, but with a few simple steps, you can achieve a professional-looking finish. Here are the steps on how to apply edge banding on right angles:

Materials You'll Need:* Edge banding
* Pencil or scribe
* Measuring tape
* Scissors or utility knife
* Iron or edge banding trimmer
* Adhesive (if necessary)

Step-by-Step Instructions:1. Prepare the edge:
* Start by cleaning the edge of the workpiece to remove any dust or debris.
* Use a pencil or scribe to mark the exact location where you want the edge banding applied.
2. Measure and cut the edge banding:
* Measure the length of the edge you need to cover.
* Cut the edge banding to the desired length using scissors or a utility knife.
* Make a small notch at the end of the edge banding, about 1/4 inch from the edge. This will allow you to fold the banding over the corner.
3. Apply adhesive (if necessary):
* If the edge banding does not have pre-applied adhesive, you will need to apply it yourself.
* Use a thin layer of adhesive to the back of the edge banding.
4. Apply the edge banding:
* Align the edge banding with the marked line on the workpiece.
* Apply pressure to the edge banding using an iron or edge banding trimmer.
* Start at the center of the edge and work your way out towards the corners.
* As you approach the corner, make sure to fold the edge banding over the notch you created earlier.
* Trim any excess edge banding at the end.
5. Finish the corner:
* Use a sharp utility knife to trim any excess edge banding that may be protruding from the corner.
* You can also sand the corner lightly to smooth it out.
Tips for Applying Edge Banding on Right Angles:
* Use a sharp utility knife or edge banding trimmer to cut the edge banding. This will ensure a clean and precise cut.
* Apply even pressure when applying the edge banding to prevent any gaps or wrinkles.
* If you are using pre-applied adhesive, make sure to remove any protective film before applying the edge banding.
* If you are applying edge banding by hand, use a heat gun or blow dryer to soften the adhesive and make it easier to apply.
* Once the edge banding is applied, allow it to cool completely before trimming or sanding it.
By following these simple steps, you can easily apply edge banding on right angles and achieve a professional-looking finish.

2025-02-10

Previous：How to Apply Edging to an Umbrella

Next：Which Zunyi Edge Banding Factory Is the Best?