How to Choose the Right Inner Diameter of Edge Banding46

As a professional Chinese edge banding strip factory, we are often asked by our customers how to choose the right inner diameter (ID) of edge banding. The inner diameter is the measurement of the hole in the center of the edge banding strip. This hole is used to fit over the edge of the substrate, such as plywood or MDF. The correct inner diameter is crucial for a secure and professional-looking finish.

Factors to Consider When Choosing Inner Diameter* Thickness of the Substrate: The thickness of the substrate will determine the minimum inner diameter of the edge banding strip. The inner diameter should be slightly larger than the thickness of the substrate to allow for a snug fit.
* Material of the Substrate: Different substrates have different densities and require different amounts of pressure to achieve a secure fit. Hardwoods, such as oak or maple, require a tighter fit than softwoods, such as pine or fir.
* Type of Adhesive: The type of adhesive used to apply the edge banding strip will also affect the choice of inner diameter. Hot melt adhesives require a tighter fit than cold adhesives.
* Application Method: If the edge banding strip is being applied manually, a larger inner diameter may be necessary to allow for easier handling. If the strip is being applied with a machine, a smaller inner diameter may be possible.

Standard Inner Diameters

The most common inner diameters for edge banding strips are 0.5mm, 1.0mm, 1.5mm, and 2.0mm. However, some manufacturers also offer custom inner diameters to meet specific requirements.* 0.5mm: This is the smallest inner diameter and is suitable for very thin substrates, such as veneer or laminate.
* 1.0mm: This is a common inner diameter for substrates up to 12mm thick.
* 1.5mm: This inner diameter is suitable for substrates up to 18mm thick.
* 2.0mm: This is the largest inner diameter and is suitable for substrates over 18mm thick.

Tips for Choosing the Right Inner Diameter* If you are unsure of the correct inner diameter, it is best to err on the side of caution and choose a slightly larger diameter.
* Test the edge banding strip on a scrap piece of substrate before applying it to the final piece.
* Use a sharp blade to cut the edge banding strip to the correct length.
* Apply the edge banding strip evenly and firmly to the substrate.
* Trim any excess edge banding strip with a flush trim router.

Conclusion

Choosing the right inner diameter of edge banding strip is essential for a secure and professional-looking finish. By following the tips above, you can ensure that you select the correct inner diameter for your specific application.

2025-02-11

Previous：How You Can Maximize Productivity with a Multipurpose Edgebander Rack

Next：How Fast Can Laser Edgebanders Operate?