How to Measure for Edge Banding371

Edge banding is a thin strip of material that is applied to the edges of plywood, MDF, or other wood panels to give them a finished look. It can also be used to protect the edges of the panel from wear and tear. Edge banding is available in a variety of materials, including wood, plastic, and metal. The most common type of edge banding is made from wood veneer.

To measure for edge banding, you will need to know the length and width of the panel that you are going to be applying it to. The length of the edge banding should be equal to the perimeter of the panel. The width of the edge banding should be equal to the thickness of the panel plus the desired overhang. The overhang is the amount of edge banding that will extend beyond the edge of the panel.

Once you have measured the length and width of the edge banding, you can cut it to size. It is important to cut the edge banding accurately, as any mistakes will be visible once it is applied to the panel. You can use a miter saw or a table saw to cut the edge banding. If you are using a miter saw, be sure to use a fine-tooth blade to prevent the edge banding from chipping.

Once the edge banding is cut to size, you can apply it to the panel. There are a variety of adhesives that can be used to apply edge banding, including contact cement, hot melt adhesive, and wood glue. The type of adhesive that you use will depend on the material that the edge banding is made from.

To apply the edge banding, first apply a thin layer of adhesive to the edge of the panel. Then, press the edge banding into place. Be sure to apply even pressure to the entire length of the edge banding. Once the edge banding is in place, you can use a roller or a hammer to press it down firmly. Allow the adhesive to dry completely before using the panel.

Here are some additional tips for measuring and applying edge banding:
If you are unsure about how to measure or apply edge banding, it is best to consult with a professional.
When cutting the edge banding, be sure to use a sharp blade to prevent the edge banding from chipping.
Apply a thin layer of adhesive to the edge of the panel before applying the edge banding.
Press the edge banding into place and apply even pressure to the entire length of the edge banding.
Allow the adhesive to dry completely before using the panel.

2025-02-11

Previous：How to Adjust the Top and Bottom of a Furniture Edge Banding Machine

Next：How to Repair Veneer Edging on Bare Carcasses