How to Apply Edge Banding by Hand328

##
Introduction:
Edge banding is a thin strip of material applied to the exposed edges of plywood, particleboard, or other wood-based panels to conceal the raw edge and provide a finished look. Applying edge banding by hand is a straightforward process that requires a few basic tools and materials.
Materials Required:
* Edge banding
* Wood glue
* Iron or heat gun
* Trimming tool (e.g., utility knife or trimming router)
* Sandpaper
* Damp cloth
Step 1: Prepare the Edge
* Clean the edge of the panel to be banded. Remove any dirt, dust, or adhesive residue.
* Apply a thin, even layer of wood glue to the edge. Spread the glue evenly using a brush or your finger.
Step 2: Apply the Edge Banding
* Place the edge banding on the glued edge and align it flush with the surface.
* Use your fingers or a clean cloth to apply even pressure along the length of the banding. Press it firmly into the glue.
Step 3: Heat the Banding
* Heat the edge banding using an iron set to medium heat or a heat gun set to a low setting.
* Hold the iron or heat gun approximately 1 inch above the banding and move it along the length. The heat will soften the banding and activate the glue.
Step 4: Trim the Banding
* Once the banding is cooled, trim off any excess material. Use a utility knife or trimming router to cut the banding flush with the edge of the panel.
Step 5: Sand and Clean
* Lightly sand the trimmed edge to smooth any rough edges or excess glue.
* Wipe the edge with a damp cloth to remove any dust or debris.
Tips:
* For optimal bonding strength, let the glue dry completely before trimming the banding.
* If you are using an iron, be careful not to burn the banding.
* If you are using a heat gun, hold it at an angle to avoid overheating the banding.
* Trim the banding carefully to avoid any splitting or delamination.
Conclusion:
Applying edge banding by hand is a simple and effective way to finish the edges of wood panels. By following these steps and using the appropriate tools and materials, you can achieve professional-looking results.

2025-02-13

---

Previous：Which Side of the MDF Should the Edge Banding Be Offset To?

Next：How to Determine the Quality of Wardrobe Edging Strip