How Much Overhang Should You Allow on the Front and Back of Veneer Edge Banding?292

When applying veneer edge banding to your furniture projects, it is important to leave a slight overhang on both the front and back of the banding. This overhang will help to ensure a clean and professional finish, and will also help to prevent the banding from peeling or coming loose over time. The amount of overhang you should leave will vary depending on the thickness of the banding and the type of adhesive you are using. However, a general rule of thumb is to leave about 1/16th of an inch of overhang on both the front and back of the banding.

To apply the veneer edge banding with an overhang, simply follow these steps:1. Apply a thin layer of adhesive to the back of the banding.
2. Align the banding with the edge of the workpiece, and then press it into place.
3. Use a roller or a burnishing tool to smooth out the banding and remove any air bubbles.
4. Trim the excess banding from the front and back of the workpiece using a sharp knife or a flush trim saw.
5. Sand the edges of the banding to smooth them out and make them flush with the workpiece.

By following these steps, you can ensure that your veneer edge banding is applied with a clean and professional finish. The slight overhang on the front and back of the banding will help to prevent the banding from peeling or coming loose over time.

Here are some additional tips for applying veneer edge banding with an overhang:
Use a sharp knife or a flush trim saw to trim the excess banding. A dull knife will tear the banding and leave a ragged edge.
Sand the edges of the banding to smooth them out and make them flush with the workpiece. This will help to create a seamless transition between the banding and the workpiece.
If you are using a thick veneer edge banding, you may need to increase the amount of overhang. This will help to prevent the banding from buckling or warping.
If you are using a strong adhesive, you may be able to get away with using less overhang. However, it is always better to err on the side of caution and leave a little bit too much overhang than not enough.

By following these tips, you can ensure that your veneer edge banding is applied with a clean and professional finish. The slight overhang on the front and back of the banding will help to prevent the banding from peeling or coming loose over time.

2025-02-14

Previous：Do Chinese Furniture Edging Strips Have Letters Printed on Them?

Next：How to Adjust the Length of Furniture Edge Bands