How to Load an Edge Banding Strip onto an Edge Bander166

Edge banding strips are used to cover the exposed edges of plywood, particle board, or other wood products. They come in a variety of materials and colors. The most common materials are PVC, ABS, and wood veneer. PVC and ABS are both plastic materials. PVC is less expensive than ABS. ABS is stronger than PVC. Wood veneer is made from a thin layer of real wood. It is the most expensive type of edge banding.

Edge banding strips are applied to the edges of wood products using an edge bander. An edge bander is a machine that applies heat and pressure to the edge banding strip. This causes the adhesive on the back of the strip to melt and bond to the wood product.

There are two types of edge banders: manual and automatic. Manual edge banders are operated by hand. Automatic edge banders are automated. Automatic edge banders are more expensive than manual edge banders, but they are faster and more efficient.

If you are new to edge banding, it is important to practice on a scrap piece of wood before you start working on your actual project. This will help you get the hang of the process and avoid mistakes.

Here are the steps on how to load an edge banding strip onto an edge bander:

Make sure that the edge bander is turned off and unplugged.

Open the door of the edge bander.

Place the edge banding strip on the conveyor belt. The adhesive side of the strip should be facing down.

Adjust the guides on the conveyor belt so that the strip is centered.

Close the door of the edge bander.

Plug in the edge bander and turn it on.

Set the temperature and speed of the edge bander according to the manufacturer's instructions.

Start the edge bander.

The edge banding strip will be fed through the edge bander and bonded to the edge of the wood product.

Once the edge banding strip has been applied, turn off the edge bander and unplug it.

Allow the adhesive to cool and cure before handling the wood product.

Here are some tips for loading an edge banding strip onto an edge bander:

Make sure that the edge banding strip is the correct size for the edge of the wood product.

The adhesive side of the strip should be clean and free of dust and debris.

The guides on the conveyor belt should be adjusted so that the strip is centered.

The temperature and speed of the edge bander should be set according to the manufacturer's instructions.

By following these steps and tips, you can successfully load an edge banding strip onto an edge bander.

2025-02-17

Previous：How to Remove Window Trim

Next：Why PVC Edge Banding Keeps Peeling Off