How to Replace Wood Veneer Edge Banding212

Wood veneer edge banding is a thin strip of wood that is applied to the edges of plywood or other wood products to give them a finished look. Over time, edge banding can become damaged or worn, and it may need to be replaced. Replacing edge banding is a relatively simple task that can be done with a few basic tools.

Tools and materials you will need:
New wood veneer edge banding
Iron or edge bander
Trimmer or utility knife
Sandpaper
Tack cloth

Instructions:
Remove the old edge banding. Use a trimmer or utility knife to carefully score the edge banding along the length of the edge. Be careful not to cut into the plywood or other wood substrate.
Clean the edge. Use a tack cloth to remove any dust or debris from the edge of the plywood.
Apply the new edge banding. Cut the new edge banding to the length of the edge. Apply a thin layer of glue to the back of the edge banding and press it into place on the edge of the plywood. Use an iron or edge bander to heat the edge banding and activate the glue.
Trim the excess edge banding. Use a trimmer or utility knife to trim the excess edge banding flush with the edge of the plywood.
Sand the edge. Use sandpaper to smooth the edge of the edge banding and blend it with the plywood.

Tips:
Use a sharp blade when scoring the old edge banding. A dull blade can tear the edge banding and make it difficult to remove.
Be careful not to overheat the edge banding when applying it with an iron or edge bander. Overheating can cause the edge banding to bubble or blister.
Allow the glue to dry completely before sanding the edge. This will help to ensure that the edge banding is securely attached.

Replacing wood veneer edge banding is a relatively simple task that can be done with a few basic tools. By following these instructions, you can give your wood products a fresh, finished look.

2025-02-17

Previous：How to Edge Band a Stair Tread

Next：How to Sand Mitered Edge Banding: A Comprehensive Guide