How to End Furniture Edge Banding: A Step-by-Step Video Guide28

Edge banding is an essential part of furniture making. It provides a finished look to the edges of your furniture, protecting it from moisture and wear. However, applying edge banding can be tricky, especially if you're not sure how to end it properly. In this video, we'll show you how to end edge banding correctly, using a simple step-by-step process.

Step 1: Cut the edge banding to size

The first step is to cut the edge banding to the correct length. To do this, measure the length of the edge you're applying it to, and then add about 1-2 inches to the measurement. This will give you enough extra banding to overhang the ends of the edge.

Step 2: Apply glue to the edge

Once you've cut the edge banding to size, apply a thin layer of glue to the edge of the furniture. Be sure to apply the glue evenly, and don't use too much. Otherwise, the glue will squeeze out from under the edge banding when you apply it.

Step 3: Apply the edge banding

Next, apply the edge banding to the glued edge. Start at one end of the edge, and slowly work your way to the other end. Be sure to press the edge banding firmly into place as you go.

Step 4: Trim the excess edge banding

Once you've applied the edge banding, trim the excess off the ends of the edge. To do this, use a sharp knife or a utility knife. Be sure to cut the edge banding flush with the edge of the furniture.

Step 5: Sand the edge

Finally, sand the edge of the furniture to smooth out any rough edges. To do this, use a fine-grit sandpaper and work your way from the center of the edge to the outside.

That's it! You've now successfully ended edge banding on your furniture. With a little practice, you'll be able to do it quickly and easily.

Additional tips

Here are a few additional tips for ending edge banding:
Use a sharp knife or utility knife to trim the excess edge banding. A dull knife will tear the edge banding, leaving a rough edge.
Be sure to sand the edge of the furniture after trimming the excess edge banding. This will help to smooth out any rough edges and give the edge a finished look.
If you're applying edge banding to a curved edge, use a heat gun or a hair dryer to soften the banding before applying it. This will make it easier to conform to the curve.

2025-02-20

Previous：How to Polish Veneer Edge Banding: A Comprehensive Guide for Woodworkers

Next：Edges of Furniture Veneer: How to Choose the Right Width